Electrolux ESL63010 Bedienungsanleitung PDF herunterladen (Seite 18)

Installation

Warning! Any electrical and/or

plumbing work required to install

this appliance should be carried out

by a qualified electrician and/or

plumber or competent person.

Remove all packaging before positioning the

machine.

If possible, position the machine next to a

water tap and a drain.

This dishwasher is designed to be fitted un-

der a kitchen counter or work surface.

Attention! Carefully follow the instructions

on the enclosed template for building in the

dishwasher and fitting the furniture panel.

No further openings for the venting of the

dishwasher are required, but only to let the

water fill and drain hose and power supply

cable pass through.

The dishwasher incorporates adjustable feet

to allow the adjustment of the height.

During all operations that involve accessibility

to internal components the dishwasher has

to be unplugged.

When inserting the machine, ensure that the

water inlet hose, the drain hose and the sup-

ply cable are not kinked or squashed.

Fixing to the adjacent units

The dishwasher must be secured against tilt-

ing.

Therefore make sure that the counter it is

fixed under, is suitably secured to a fixed

structure (adjacent kitchen units cabinets,

wall).

Levelling

Good levelling is essential for correct closure

and sealing of the door.

When the appliance is correctly levelled, the

door will not catch on either side of the cab-

inet .

If the door does not close correctly, loosen

or tighten the adjustable feet until the ma-

chine is perfectly level.

Water connection

Water inlet connection

This appliance must be connected to a cold

water supply.

For making the connection itself, the cou-

pling nut fitted to the appliance water inlet

hose is designed to screw onto a 3/4" thread

spout or to a purpose made quick-coupling

tap such as the Press-block.

The water pressure must be within the limits

given in the 'Technical data'. Your local Wa-

ter Authority will advise you on the average

mains pressure in your area.

The water inlet hose must not be kinked,

crushed, or entangled when it is being con-

nected.

The appliance features inlet and drain hoses

which can be turned either to the left or the

right to suit the installation by means of the

locknut. The locknut must be correctly

fitted to avoid water leaks.

Attention! NOT all dishwasher models of

have inlet and drain hoses provided with

a locknut. In this case, this facility is not

available.

If the appliance is connected to new pipes or

pipes which have not been used for a long

time, you should run the water for a few mi-

nutes before connecting the inlet hose.

DO NOT use connection hoses which

have previously been used on an old ap-

pliance.

This appliance has been fitted with safe-

ty features which will prevent the water

used in the appliance from returning

back into the drinking water system. This

appliance complies with the applicable

plumbing regulations.

Water drain connection

The end of the drain hose can be connected

in the following ways:

1. To the sink outlet spigot, securing it to the

underside of the work surface. This will

prevent waste water from the sink run-

ning into the machine.

2. To a stand pipe provided with venthole,

minimum internal diameter 4 cm.

The waste connection must be at a height of

between 30 cm (minimum) and 100 cm

18 electrolux

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare