Electrolux EI23BC80KS Bedienungsanweisung PDF herunterladen (Seite 30)

Common Solutions for Concerns

Before you call...

If you experience a concern with your refrigerator or notice a product behavior or condition that you do not

understand, you can usually avoid a call to your service representative by referring to this section for an answer.

Beginning with the following table, this information includes concerns, potential causes, and common solutions.

Automatic Ice Maker

Concern Potential Cause Common Solution

Ice maker is not

making any ice.

• Ice maker is turned off.

• Refrigerator is not connected to water line

or water valve is not open.

• The water supply line is kinked.

• The water ﬁlter is not seated properly.

• The water ﬁlter may be clogged with

foreign material.

• Saddle valve on cold water pipe is

clogged or restricted by foreign material.

• Lower the wire signal arm.

• Connect the unit to the household water supply

and ensure the supply valve is open.

• Ensure that the supply line does not kink when the

refrigerator is pushed into place against the wall.

• Remove and re-install the water ﬁlter. Be sure to

push the ﬁlter ﬁrmly so that you hear it lock solidly

into position.

• If water dispenses slowly or not at all, or if the ﬁlter

is six months old or older, it should be replaced.

• Turn off household water line valve. Remove valve.

Ensure that valve is not a self-piercing saddle

valve. Clean valve. Replace valve if necessary.

Ice maker is not

making enough ice.

• Ice maker is producing less ice than you

expect.

• The water ﬁlter may be clogged with

foreign material.

• The water supply line is kinked.

• Saddle valve on cold water pipe is

clogged or restricted by foreign material.

• Freezer control is set too warm.

• The freezer ice maker will produce approximately

2.5 pounds of ice every 24 hours depending on

usage conditions.

• If the ﬁlter is six months old or older, it should be

replaced.

• Ensure that the supply line does not kink when the

refrigerator is pushed into place against the wall.

• Turn off household water line valve. Remove valve.

Ensure that valve is not a self-piercing saddle

valve. Clean valve. Replace valve if necessary.

• Set freezer control to colder setting to improve

performance of the ice maker. Allow 24 hours for

temperature to stabilize.

Ice maker will not stop

making ice.

• Ice maker wire signal arm is being held

down by some package in the freezer that

has fallen against the ice maker.

• Move the item and release wire signal arm.

Remove any ice cubes that may have frozen

together over the wire signal arm.

Ice cubes are freezing

together.

• Ice cubes are not being used frequently

enough.

• Ice cubes are hollow (shells of ice with

water inside). The hollow cubes break open

in the bin and leak their water onto existing

ice, which causes it to freeze together.

• Remove ice container and discard ice. The ice maker

will produce fresh supply. Ice should be used at

least twice weekly to keep the cubes separated.

• This generally occurs when the ice maker does not

get enough water. This is usually the result of a

clogged water ﬁlter. Replace the water ﬁlter.

1 2 ... 25 26 27 28 29 30 31 32 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux EI23BC80KS Bedienungsanweisung Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Side-by-Side-Kühl- und Gefrierschränke Electrolux EI23BC80KS