Electrolux EXP09HN1W6 Bedienungsanleitung PDF herunterladen (Seite 33)

33ENGLISH

Note: This feature is unavailabe under

FAN or DRY modes.

FAULT CODE:

If the display reads “E1”, the room

temperature sensor has failed. Call for

service.

If the display reads “E2”, the evaporator

temperature sensor has failed. Call for

service.

temp/timer setting

temp/timer setting

temp/timer setting

temp/timer setting

temp/timer setting

DRAINAGE:

The hose may then:

Fig.25

1. During the dehumidifying mode, you will

need a garden hose (sold separately)

to drain the condensate from the unit.

Remove the rubber stopper from the

hose connector, then screw on a garden

hose to the connector as shown on

Fig.25.

A. Discharge into a drain that is lower than

the unit.

B. Be connected to a condensate pump

(sold separately).

Garden hose

Remove the

supplied rubber

stopper

SLEEP OPERATION:

SWING OPERATION:

POWER MANAGEMENT FEATURE:

In this mode the selected temperature

will increase by 1 °C 30 minutes after

the mode is selected. The temperature

will then increase by another 1 °C after

an additional 30 minutes. This new

temperature will be maintained for 7 hours

before it returns to the originally selected

temperature. This ends the “Sleep” mode

and the unit will continue to operate as

originally programmed. The “Sleep” mode

program can be cancelled at any time

during operation by again pressing the

“Sleep” button.

When you turn on the unit, the louver will

swing and stop at a certain angle. You can

press the SWING button to let the louver

swing automatically. Press the SWING

button again while you want the louver

stop at desired angle.

When the ambient temperature reaches

the setting temperature, after a period of

time the unit will automatically switch to

power management mode. The power

management indicator light "

" will

illuminate and the unit will be turned off.

When the ambient temperature varies from

the setting temperature, after a period

of time the unit will automatically quit the

power management mode. The indicator

light will be turned off and the unit will be

turned on again.

If the display reads “P1”, bottom tray is full.

Carefully move the unit to a drain location,

remove the bottom drain plug and let the

water drain away. Restart the machine

until the “P1” symbol disappears. If error

repeats, call for Service.

If the display reads “E4”, the display panel

communication has failed. Call for Service.

If the display reads “E3”, the condenser

temperature sensor has failed. Call for

Service.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 199 200

Kommentare zu diesen Handbüchern

Keine Kommentare