Electrolux EWF147110W Bedienungsanleitung PDF herunterladen (Seite 17)

5. place a bowl on the floor and place the

end of the emergency emptying hose in-

to the bowl. Remove its cap. The water

should drain by gravity into the bowl.

When the bowl is full, put the cap back

on the hose. Empty the bowl. Repeat

the procedure until water stops flowing

out;

6. clean the pump if necessary as previ-

ously described;

7. replace the emergency emptying hose

in its seat after having plugged it;

8. screw the pump again and close the

door.

Frost precautions

If the machine is installed in a place where

the temperature could drop below 0°C,

proceed as follows:

1. close the water tap and unscrew the

water inlet hose from the tap;

2. place the end of the emergency empty-

ing hose and that of the inlet hose in a

bowl placed on the floor and let water

drain out;

3. screw the water inlet hose back on and

reposition the emergency emptying

hose after having put the cap on again.

By doing this, any water remaining in the

machine is removed, avoiding ice forming

and consequently damage to the appliance.

When you use the machine again, make

sure that the ambient temperature is above

0°C.

Important! Every time you drain the water

through the emergency emptying hose you

must pour 2 litres of water into the main

wash compartment of the detergent drawer

and then run the drain programme. This will

activate the ECO Valve device avoiding

that part of the detergent remains unused

at next washing.

WHAT TO DO IF…

Certain problems are due to lack of simple

maintenance or oversights, which can be

solved easily without calling out an engi-

neer. Before contacting your local Service

Centre, please carry out the checks listed

below.

During machine operation it is possible that

the red pilot light of button 5 blinks to indi-

cate that the machine is not working.

It is possible to recognize the machine fault

by the number of button 5 light flashes. If

the number of flashes is different from the

ones indicated below, this is related to a

fault that you cannot solve. In this case,

contact your local Service Centre.

Press simultaneously the buttons 4 and 5

for a few seconds. The red button 5 light

will flash for a short time as described (the

green flash is not to be considered) :

•

4 flashes = «The washing machine

does not start», follow the correspond-

ing suggestions in «Possible cause/Solu-

tions» box and restart the programme.

• 1 flash = «The machine does not fill»,

follow the corresponding suggestions in

«Possible cause/Solutions» box and re-

start the programme.

•

2 flashes = «The machine does not

empty and/or does not spin», follow

the corresponding suggestions in «Possi-

ble cause/Solutions» box and restart the

programme.

Once the problem has been eliminated,

press the button 5 to restart the pro-

gramme. If after all checks, the problem

persists, contact your local Service Centre.

electrolux 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare