Electrolux EW30DS80RS Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 10)

10 Before Setting Surface Controls

For the 18 000 BTU burner:

Place the burner head over the gas orifice (Figure 8). Be careful

not to damage the electrode while placing the burner head over

the orifice. Make sure electrode fits correctly into slot in burner

head.

IMPORTANT! For proper ignition, the burner ring alignment tab

must align with burner base alignment tab slot.

When the burner ring is properly seated, it will click into place.

When the burner cap is properly set in place, it should not move

out of the recessed area of the burner head.

INSTALLING BURNER GRATES

Surface burners may appear to have cooled after they have

been turned off. The surface burner may still be hot and burns

may occur if the surface burner is touched before it has cooled

sufficiently.

Make sure the burner grates are properly placed on the cooktop

before using the surface burners. The grates are designed to

rest inside the recess on the cooktop.

To install burner grates, place grates flat-side down and align

into the cooktop recess. Grates should rest flush against each

other and against the sides of the recess (Figure 10).

Figure 8: Setting G5 burner correctly

Figure 9: 18 000 BTU burner cap and head

Ring

Alignment Tab

Burner

Cap

Burner

Ring

Burner

Base

Simmer

Head

Burner

Alignment

Tab

Slot

Burner

Figure 10: Burner grates placement

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Keine Kommentare

Electrolux EW30DS80RS Gebrauchs- und Pflegeanleitung Seite 10