Electrolux ERD28304W8 Bedienungsanleitung PDF herunterladen (Seite 37)

electrolux 37

GB

Problem

It is too warm in the

refrigerator.

It is too warm in the

freezer.

Water flows at the

back plate of the

refrigerator.

Water flows into the

chamber.

Water flows onto the

floor.

There are too much

frost and ice.

Possible cause

Thermostatic control can be

set wrongly.

If products are not cold

enough or placed wrongly.

The door does not close

tightly or it is not shut

properly.

Thermostatic control can be

set wrongly.

The door does not close

tightly or it is not shut

properly.

Products in big quantity to be

frozen were put in.

Products to be frozen are

placed too closely to each

other.

It is normal. During automatic

defrosting frost melts on the

back plate.

The outlet of the chamber can

be clogged up.

Products placed in can

prevent water from flowing

into the collector.

The melting water outlet flows

not into the evaporative tray

above the compressor.

Products are not wrapped

properly.

Doors are not shut properly or

do not close tightly.

The thermostatic control can

be set wrongly.

Solution

Set the thermostat knob to

higher position.

Place the products to the

appropriate place.

Check if the door closes well

and the gasket is unhurt and

clean.

Set the thermostat knob to

higher position.

Check if the door closes well

and the gasket is unhurt and

clean.

Wait some hours and then

check the temperature again.

Place the products in a way so

that cold air could circulate

among them.

Clean the outlet.

Replace the products so that

they can not touch the back

plate directly.

Put the melting water outlet to

the evaporative tray.

Wrap the products better.

Check if the doors close well

and the gaskets are unhurt and

clean.

Set the thermostat knob to a

position that gives higher

temperature.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare