Electrolux Refrigerator FKCH17F7HW Bedienungsanleitung

REFRIGERATOR/FREEZER SERVICE MANUAL #5995519443 2008 ALL RIGHTS RESERVED ConvertibleRefrigerator / FreezerModel FKCH17F7HWTechn

2-2Electronic ControlElectronic Temperature ControlThe electronic temperature controls are located on theevaporator cover in the upper right hand corn

Operation of Electrical Control ComponentsFreezer and Refrigerator ModulesThe modules, when selected by the rocker switch, control the temperature of

2-4Electronic ControlService Diagnostic ModeInitiate Service ModeThe refrigerator and freezer controls have individual service modes. Each control as

2-5Electronic ControlError IndicationThe following error conditions are monitored by each electronic control assembly:1. Thermistor open or shorted.

2-6Electronic ControlNotes

3-1Refrigeration SystemSection 3Refrigeration System

3-2Refrigeration SystemInstructions given here are furnished as a guide.Persons attempting to use these instructions tomake repairs to the sealed refr

1. All joints to be soldered must have proper fit. Clearance between tubes to be soldered should befrom .001” to .006”. It is not practical to actu

3-4Refrigeration SystemLow/High Side Leak or UnderchargeA loss of refrigerant can result in any of the following:1. Excessive or continuous compress

3-5Refrigeration SystemTo Flush The SystemTo Use Dry Nitrogen To Flush The System:1. Remove compressor and filter-drier. Connectprocess coupling to

A new compressor which is cold (e.g. after having beenkept in a cold service van) should be left to warm to thesurrounding temperature before the plug

Condenser Replacement1. Disconnect electrical supply to refrigerator.2. Remove compressor access panel.3. Recover refrigerant by using EPA appro

Filter-Drier InstallationAny time the sealed system is opened and the refrigerant charge is removed, the liquid line filter-driermust be replaced and

3-9Refrigeration SystemEquipment Needed for Evacuation &Recharging:• Heated charging cylinder• Standard 3-port manifold gauge set:- 4 charging ho

3-10Refrigeration SystemEvacuating SystemTo achieve the required levels of evacuation, a properlymaintained two stage vacuum pump in good condition is

3-11Refrigeration System10. Slowly open the high-side manifold gauge valve toallow the compressor to remove any refrigeranttrapped in the high-side ho

3-12Refrigeration SystemVerify Refrigerant Type In The SystemDedicated EquipmentR-134a must not be mixed with other types of refrigerants. R-134a mus

3-13Refrigeration SystemTo achieve the required 29.9 inch (500 micron) vacuum,a properly maintained two-stage vacuum pump in goodcondition is required

3-14Refrigeration SystemVacuum Pump MaintenanceIt is absolutely essential to maintain your vacuum pumpaccording to the manufacturer’s instructions inc

3-15Refrigeration SystemLeak DetectionR-134a system leaks can be pinpointed by means of anelectronic leak detector or by bubble solution.Electronic le

Basic Information1-1Section 1Basic Information

3-16Refrigeration SystemHFC-134a, CFC-12 Pressure Temperature Chart

3-17Refrigeration SystemInhalation ToxicityHFC-134a poses no acute or chronic hazard when it ishandled in accordance with DuPont recommendationsand wh

3-18Refrigeration SystemCombustibility of HFC-134aHFC-134a is nonflammable at ambient temperatures and atmospheric pressure. However, testshave shown

4-1Component TeardownSection 4Component Teardown

4-2Component Teardown- Metal edges may be sharp. Use caution and wear appropriate safety equipment when servicing evaporators and condensers to avoid

4-3Component TeardownExterior ComponentsDoor Handle RemovalThe door handle is secured to the door assembly withtwo set screws in the door handle that

4-4Component TeardownFigure 5-6. Inner Panel and Door Gasket RemovalDoor Stop RemovalThe door stop is mounted to the underside of the doorassembly an

4-5Component TeardownFigure 5-8. Control RemovalGallon Door Bin RemovalThe gallon door bin has slots on each end that fit overmolded slots in the doo

4-6Component TeardownFigure 5-10. Door Switch RemovalFigure 5-11. Glass Shelf Assembly RemovalDoor Switch RemovalThe door switch is mounted inside a

4-7Component TeardownCrisper Cover Assembly Removal The crisper cover assembly slides into a slot formed inthe left and right hand supports that are s

Basic Information1-2Section 1 - Basic Information ... 1-1Table of Contents ...

4-8Component TeardownBaffle Plate RemovalThe baffle plate is secured with four retaining latches toslots in the compartment upper back wall. (See Fig

4-9Component TeardownElectronic Control RemovalThe electronic control is secured to a housing with fourretaining latches on the inside of the evaporat

4-10Component TeardownDefrost Thermostat RemovalThe defrost thermostat is secured with a retaining clip tothe upper left corner of the evaporator asse

4-11Component TeardownFigure 5-24. Filter-Drier RemovalOn R-134a systems, the system must NOT be left open to the atmosphere for more than 10minutes

4-12Component TeardownCompressor RemovalThe compressor sits on four grommets and is securedwith four screws to the compressor mounting plate.(See Figu

4-13Component TeardownDrain Pan and Drain Pan Heater Loop RemovalThe drain pan heater loop is clamped to the drain panwith two brackets and secured wi

4-14Component TeardownCondenser ServiceThe condenser is foamed in place and is not accessiblefor repair. However, repair can be made by installing a

5-1TroubleshootingSection 5Troubleshooting

Refrigerator/Freezer is plugged into a circuit that has a ground fault interrupt.Temperature control is in the "OFF" posi-tion.Refrigerator

Modern Freezers have increased storagecapacity and more stable temperatures.They require heavy duty compressors.Refrigerator/Freezer operates at high

Safe Servicing PracticesAvoid personal injury and/or property damage byobserving important Safe Servicing Practices. Following are some limited examp

5-4TroubleshootingCompressor and evapora-tor fan motor does not run.Compressor does not run,but the evaporator fanmotor does.Evaporator fan motor does

5-5Troubleshooting1. Program the control for a manual defrost. Does the defrost operate?2. Disconnect the orange wire from the defrost thermostat and

5-6TroubleshootingNotes

6-1Wiring DiagramsSection 6Wiring Diagrams

6-2Wiring Diagrams74628351

6-3Wiring DiagramsTemp °C Temp °F Nominal Resistance Max. Ohms Min. Ohms ToleranceOhms % +/-0° 32° 32,654 33,604.72 31703.29 2.91-15° 5° 72,940 75,283

7-1Section 7Installation InformationInstallation Information

7-2Installation InformationIMPORTANT SAFETY INSTRUCTIONSSafety PrecautionsDo not attempt to install or operate this appliance until you read the safet

7-3Installation InformationDESTROY CARTON, PLASTIC BAGS, AND ANY EXTERIOR WRAPPING MATERIAL IMMEDIATELY AFTERTHE REFRIGERATOR/FREEZER IS UNPACKED. CH

7-4Installation InformationLocation1. Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an adapter plug. 2. If

Basic Information1-4Product FeaturesFrigidaire refrigerator/freezers are designed for optimal convenience and storage flexibility. Use the illustrati

7-5Installation InformationElectrical InformationThese guidelines must be followed to ensure that safetymechanisms in the design of this refrigerator/

7-6Installation InformationDoor Removal For some installations it may be necessary to removethe door to fit through the entrance of the installationsi

7-7Installation Information⅛⅛¾Model FKCH17F7HW Unit Dimensions

7-8Installation InformationNotes

Basic Information1-5Door StorageDoor bins, shelves, and racks are provided for convenient storage of jars, bottles, and cans. Frequentlyused items can

Basic Information1-6Serial PlateThe serial plate is located inside the cabinet on the leftsidewall. The technician should always refer to the serial

Electronic Control2-1Section 2Electronic Control