Electrolux GK78TSIPO Bedienungsanleitung PDF herunterladen (Seite 14)

Incorrect cookware position:

5.4 FlexiBridge Max Bridge

mode

To activate the mode press until you

see the correct mode indicator . This

mode connects all sections into one

cooking zone. To set the heat setting use

any of the two control bars on the left

side.

Correct cookware position:

To use this mode you have to place the

cookware on the four connected sections.

If you use cookware smaller than three

sections the display shows and after 2

minutes the zone switches off.

Incorrect cookware position:

5.5 PowerSlide function

This function allows you to adjust the

temperature by moving the cookware to a

different position on the induction cooking

area.

The function divides the induction cooking

area into three areas with different heat

settings. The sides of the areas in this

mode illuminate. The hob detects the

position of the cookware and adjust the

heat setting corresponding with the

position. You can place the cookware in

the front, middle or rear position. If you

place the cookware in the front you get

the highest heat setting. To decrease it,

move the cookware to middle or rear

position.

Use only one pot when you

operate the function.

General information:

• 160 mm is the minimum bottom

diameter of the cookware for this

function.

• Heat setting display for the left rear

control bar shows the position of the

cookware on the induction cooking

www.electrolux.com14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare