Electrolux EGG9353NOX Bedienungsanleitung

EGG9353... ...EN HOB USER MANUAL

of 100 cm² is required. If it is installed in aroom of volume between 5 m³ and 10 m³an air vent of effective area of 50 cm² isrequired, while if the v

of gas you use (see table in "Techni-cal Information" chapter).4.Assemble the parts, follow the sameprocedure backwards.5.Replace the rating

ABCDEA)Green and YellowB)3 amp fuseC)BrownD)Cord clampE)BlueShould the plug need to be replaced forany reason, the wires in the mains leadare coloured

7.8 Possibilities for insertionKitchen unit with doorThe panel installed below the hob mustbe easy to remove and let an easy accessin case a technical

By-pass diametersBurner Ø By-pass in1/100 mmAuxiliary 28Semi-rapid 32Burner Ø By-pass in1/100 mmRapid 42Triple Crown 56Gas burnersBURN-ERNOR-MALPOWERR

ENGLISH 15

www.electrolux.com/shop356993601-A-122012

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. PRODUCT DESCRIP

1. SAFETY INFORMATIONThis appliance is suitable for the followingmarkets: IE GBBefore the installation and use of the ap-pliance, carefully read th

nect the appliance from the mains at allpoles. The isolation device must have acontact opening width of minimum 3mm.• Use only correct isolation devic

1.4 Care and CleaningWARNING!Risk of damage to the appliance.• Clean regularly the appliance to preventthe deterioration of the surface material.• Do

Always light the burner before youput cookware.To light the burner:1.Turn the control knob counterclock-wise to the maximum position ( ) and push it

• When the liquid starts to boil, turn downthe flame to barely simmer the liquid.Use cookware with diameters applicableto the size of burners.Burner D

The stainless steel can become tarnishedif it is too much heated. Refer to this youmust not cook with potstones, earthen-ware pans or cast iron plates

These data are necessary to help youquickly and correctly. These data areavailable on the supplied rating plate.• Model description .....•