10
FITTING THE GAS HOB
WITHOUT A COOKER HOOD ABOVE
FITTING THE GAS HOB
WITH A COOKER HOOD ABOVE
700 mm
400 mm
400 mm
100 mm
55 mm
50 mm
50 mm
600 mm
700 mm
400 mm
400 mm
100 mm
55 mm
600 mm
50 mm
50 mm
FO 2369*
FO 2231*
Important safety requirements
This hob must be installed in accordance with the Gas
Safety (Installation and Use) Regulations (Current Edition)
and the IEE Wiring Regulations (Current Edition).
For appliances installed in the Republic of Ireland please
refer to NSAI- Domestic Gas Installation I.S. 813 Current
Editions and the ETCI Rules for Electrical Installations.
Provision for Ventilation
Detailed recommendations are contained in the following
British Standards Codes Of Practice: B.S. 6172/ B.S. 5440,
Part 2 and B.S. 6891 Current Editions.
The hob should not be installed in a bed sitting room with a
volume of less than 20 m
3
. If it is installed in a room of
volume less than 5 m
3
an air vent of effective area of 110
cm
2
is required. If it is installed in a room of volume between
5 m
3
and 10 m
3
an air vent of effective area of 50 cm
2
is
required, while if the volume exceeds 11 m
3
no air vent is
required.
However, if the room has a door which opens directly to the
outside no air vent is required even if the volume is between
5 m
3
and 11 m
3
. If there are other fuel burning appliances in
the same room, B.S. 5440 Part 2 Current Edition, should
be consulted to determine the requisite air vent requirements.
For appliances installed in the Republic of Ireland please
refer to the NSAI- Domestic Gas Installation I.S. 813 Current
Editions Table Four.
Location
The hob may be located in a kitchen, a kitchen/diner or bed
sitting room, but not in a bathroom or shower room.
Before making the cut out in the worktop ensure that the
edges of the hob that are to be near either a side or rear
wall have a minimum distance of 55 mm between the edge
of the hob and the wall.
The minimum distance combustible material can be fitted
above the hob is 400 mm. If it is fitted below 400 mm a
space of 50 mm must be allowed from the edges of the
hob. The minimum distance combustible material can be
fitted directly above the hob is 700 mm. A minimum distance
of 100 mm must be left between the side edges of the hob
and any adjacent cabinets or walls.
For appliances installed in the Republic of Ireland please
refer to NSAI- Domestic Gas Installation I.S 813 Current
Edition Section 7- Permitted Locations of Appliance.
Installation
IMPORTANT
This hob must be installed by a competent
person to the relevant Gas Standards.
Any gas installation must be carried out by a
registered competent person.
The manufacturer will not accept liability, should
the above instructions or any of the other safety
instructions incorporated in this book be ignored.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important
to remove any protective materials, which were
put on in the factory.
On the end of the shaft, which includes the GJ 1/2" threaded
elbow, adjustment is fixed so that the washer is fitted between
the components as shown in the diagram. Screw the parts
together without using excessive force.
(16 Seiten)
(20 Seiten)
(32 Seiten)
(48 Seiten)
(28 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern