Electrolux EKK61500OW Bedienungsanleitung PDF herunterladen (Seite 26)

If the supply gas pressure is not constant

or it is different from the necessary

pressure, install an applicable pressure

adjuster on the gas supply pipe.

14.11 Adjusting the minimum

gas level on the hob burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the hob. If there

is no access to the bypass screw

dismount the control panel before

adjustment start.

3. With a thin and flat screwdriver adjust

the bypass screw A.

The model determines the position of

the bypass screw A.

A

A

Changing from natural gas to

liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to

natural gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the

electricity.

WARNING!

Put the mains plug into

the mains socket only if

all parts are back into

their initial position.

There is a risk of injury.

4. Light the burner.

Refer to "Hob - Daily use" chapter.

5. Turn the knob for the hob to the

minimum position.

6. Remove the knob for the hob again.

7. Screw on slowly the bypass screw till

the flame becomes minimum and

stable.

8. Put the knob for the hob back on.

14.12 Levelling of the appliance

Use small feet on the bottom of

appliance to set the appliance top

surface level with other surfaces.

14.13 Anti-tilt protection

Set the correct height and area for the

appliance before you attach the anti-tilt

protection.

CAUTION!

Make sure you install the

anti-tilt protection at the

correct height.

Make sure that the surface

behind the appliance is

smooth.

You must install the anti-tilt protection. If

you do not install it, the appliance can tilt.

Your appliance has the symbol shown on

the picture (if applicable) to remind you

about the installation of the anti-tilt

protection.

www.electrolux.com26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare