Electrolux EQW4111BOZ Bedienungsanleitung PDF herunterladen (Seite 11)

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the

information bellow from the rating plate.

The rating plate is on the bottom of the

hob.

Model .......................................

PNC .........................................

Serial number ...........................

8.2 Gas Connection

WARNING!

The following instructions

about installation, connection

and maintenance must be

carried out by qualified

personnel in compliance with

standards and local

regulations in force.

Make sure that during the installation the

appliance is not connected to electrical

supply. Disconnect the mains plug or

deactivate the fuses. Disconnect the

mains gas supply.

Make sure that there is a stop tap

assembles between the gas supply of

house and the appliance.

The settings for this appliance are located

on the rating plate. The present settings

for the type of gas and gas pressure are

on a sticker.

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

This appliance is not connected to an

exhaust gas outlet. It must be connected

in accordance with the installation

conditions that apply. Pay special

attention to correct airflow.

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values. The

adjustable connection is fixed

to the comprehensive ramp

by means of a threaded nut.

G 1/2". Screw the parts

without force, adjust the

connection in the necessary

direction and tighten

everything.

A B C

A) End of shaft

B) Washer

C) Elbow (if needed)

Flexible nonmetal pipes connection:

If it is possible to easily control the

connection in its full area, you can use a

flexible pipe. Tightly attach the flexible pipe

by clamps.

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

ENGLISH

11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare