Electrolux GK903TSIO Bedienungsanleitung PDF herunterladen (Seite 15)

Before the installation of the appliance, re-

cord the information below from the rating

plate. The rating plate is on the bottom of

the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

WARNING!

During installation in combustible

matter, NIN SEV 1000 and fire

protection guidelines and regula-

tions of the Association of Canto-

nal Fire Insurance shall be strictly

adhered to.

8.1 Built-in appliances

• Only use the built-in appliances after

you assemble the appliance into correct

built-in units and work surfaces that

align to the standards.

8.2 Connection cable

• The appliance is supplied with the con-

nection cable.

• Replace the damaged mains cable with

a special cable (type H05VV-F or high-

er). Speak to your local Service Centre.

8.3 Electrical connection

• Install the appliance with a socket sup-

ply line. If there is no socket supply line,

the fixed home electrical system must

include an isolating device with at least

a 3 mm-contact separation to enable a

simultaneous and all-pole cut off from

the mains (according to NIN SEV 1000).

8.4 To attach the seal to the

rabbet

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the

upper surface of the rabbet along the

edges of the cut out section.

• Cut the seal stripe into four pieces in re-

lation to the length of the edges of the

rabbet.

• For the four corners of the rabbet the

ends of the seal stripes must be cut in-

to mitres. Do not bond the ends over

one another.

• Bond the seal stripe flush into the cor-

ner of the rabbet. Make sure that no sil-

icon compound can get below the

glass ceramic when grouting.

• Do not extend the tapes.

8.5 To attach the seal.

• Clean the worktop in the area of the cut

out section.

• Bond the seal stripe supplied on the

lower edge of the appliance along the

outer edge of the glass ceramic. Do not

extend it. Let stay the cut ends in the

middle of one side. When, you cut it to

length (add some mm), push the two

ends together.

8.6 Assembly

min.

450mm

min.

650mm

min.

2mm

ENGLISH 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare