Electrolux FGH50K3 Bedienungsanleitung PDF herunterladen (Seite 10)

WARNING!

The gas connection pipe

must not touch the part of

the appliance shown in the

illustration.

3.9 Flexible nonmetal pipes

connection

If you have an easy access to the

connection, you can use a flexible pipe.

The flexible pipe must be tightly attached

by clamps.

In installation always use the pipe holder

and the gasket. The flexible pipe can be

applied when:

• it can not get hotter than room

temperature, higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp

edges or corners,

• it's conditions can be easily checked.

When checking the flexible pipe make

sure:

• it does not show cracks, cuts, marks

of burnings on the two ends and on its

full length,

• the material is not hardened, but

shows its correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is

complete, make sure that

the seal of each pipe fitting

does not leak. To check the

seal use a soap solution, not

a flame.

The gas supply ramp is on the rear side

of the control panel.

WARNING!

Before you connect the gas,

disconnect the appliance

from the electricity supply or

switch off the fuse in the

fuse box. Close the primary

valve of the gas supply.

3.10 Adjustment to different

types of gas

Let only an authorized

person do the adjustment to

different types of gas.

If the appliance is set for

natural gas you can change

it to liquid gas, with the

correct injectors.

The gas rate is adjusted to

suit.

WARNING!

Before you replace the

injectors, make sure that the

gas knobs are in the Off

position. Disconnect the

appliance from the electrical

supply. Let the appliance

cool down. There is a risk of

injury.

The appliance is set to

default gas. To change the

setting always use the

gasket sealing.

A

B

D

C

A. Gas connection point (only one point

is applicable for the appliance)

B. Gasket

C. Adjustable connection

D. LPG pipe holder

3.11 Hob injectors replacement

Replace the injectors when you change

the gas type.

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. Remove the injectors with a socket

spanner 7.

www.electrolux.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare