Electrolux 2005-04 Betreibershandbuch

1Operators Manual, Super Tilematic G2, 2005-04, 542 20 10-38542 20 10-38Super Tilematic G2STM 10100 G2STM 10100SS G2Operator’s manualRead these instru

10FIGURE 12134R5EFGHNABCDQOIJKLM2M1PA. Set Collars(See Fig. 2 for Plunge Cutting Components)B. Bearing CapC. Locking KnobD. LockbarE. Water PumpF. Hos

11These signs will giveadvice for your safetyBefore leaving our factory every machine is thoroughlytested.Follow our instructions strictly and yourmac

125. Water Pump and Accessory Carton: IncludesWater Pump (E), Hose Barb (F), Water Valve(G), 15/16" Wrench (N), Drain Plug (P), LockingKnob (C)

13WARNING: Read the Operating Procedurecompletely before operating your tile saw.Take into account the working conditions fromthe health and safety po

14Good motor performance depends on propervoltage. Extension cords that are too longand/or too small in wire gauge reduce thevoltage to the motor und

15Before performing any maintenance, ALWAYSplace the machine on a level surface with themotor OFF and disconnect the electricalcurrent. Let the machi

16The instructions for use and spare parts found in this document are for information only and are not binding. As partof our product quality improve

17Diagram 1: Wiring Diagram 542 20 30-79, 1.5HP, 115V/60/1

18Diagram 2: Wiring Diagram 542 00 06-05, 1.5 HP, 115V/208-230/60/1

19Serial Number:Model Number:Date of Purchase:Where Purchased:Target’s Gold Medal Equipment WarrantyNew equipment sold by Target is warranted to be fr

2EVERY MACHINE IS THOROUGHLY TESTED BEFORE LEAVING THE FACTORY. EACH MACHINE IS SUPPLIEDWITH A COPY OF THIS MANUAL. OPERATORS OF THIS EQUIPMENT MUST

Target Corporate Office17400 West 119th StreetOlathe, Kansas 66061Customer Service: 800-288-5040Customer Serv. Fax: 800-825-0028Corporate Office: 913-

3Symbol DefinitionsSymbolesDefinición De Los Simbolos• Please read the instructions for use prior to operating the machine for the first time.• Avant

4• Motor Off• Arrêt Du Moteur• Parar El Motor• Use In Well Ventilated Area• A Utiliser Dans Un Endroit Bien Ventilé• Usar En Una Área Bien Ventilada•

5WARNINGHEARING HAZARDDURING NORMAL USE OF THIS MACHINE, OPERATOR MAY BE EXPOSED TO A NOISE LEVEL EQUAL OR SUPERIOR TO 85 dB (A)ATTENZIONE!!!RISCHIO D

6DECAL DESCRIPTIONS & LOCATIONP/N 542 18 70-43*Location: Top of Belt GuardP/N 542 04 63-26*Location: Motor AssemblyP/N 542 04 63-27*Location: Mot

7DECAL DESCRIPTIONS & LOCATIONP/N 542 18 97-36*Location: Front of PanP/N 542 18 97-31*Location: Blade Guard & Belt GuardP/N 542 18 76-91*Loc

8DO read this entire operator’s manual before operating this machine. Understand all warnings, instructions, and controls.DO keep all guards in place

9DO NOT operate this machine unless you have read and understood this operator’s manual.DO NOT operate this machine without the blade guard, or other