Electrolux EASX24C5ATLW Bedienungsanleitung PDF herunterladen (Seite 22)

Electric safety regulations for the initial

Installation

1. If there is serious safety problem about

the power supply, the technicians

should refuse to install the air

conditioner and explain to the client

until the problem is solved.

2. Power voltage should be in the range of

90%~110%of rated voltage.

3. The surge protector and main power

switch with a 1.5 times capacity of

Max. Current of the unit should be

installed in power circuit.

4. Ensure the air conditioner is grounded

well.

5. According to the attached Electrical

Connection Diagram located on the

panel of the outdoor unit to connect

the wire.

6. All wiring must comply with local and

national electrical codes and be

installed by qualified and skilled

electricians.

7. An individual branch circuit and single

receptacle used only for this air

conditioner must be avaliable. See the

following specifications:

Connect the cable to the indoor unit

Electrical box

cover

21 electrolux electrical work

Rated current

of appliance (A)

>3 and ≤6

>6 and ≥10

>10 and ≥16

>16 and ≥25

Nominal cross-sectional

area (mm2)

0.75

1

1.5

2.5

The cable size and the current

of the fuse or switch are

determined by the maximum

current indicated on the

nameplate which located on

the side panel of the unit.

Please refer to the nameplate

before selecting the cable, fuse

and switch.

remote control electrolux 34

When should the batteries be

replaced

1. When there is not a “beep”

anymore from the indoor unit

when using the control remote or

the signal light indicator does not

lit.

2. The indoor unit does not respond

to the remote control commands

to activate the programs.

To replace batteries

1. Slide out the battery

compartment cover ( located in

the back part of the remote

control).

2. Install the two AAA batteries in

the compartment (indicated in the

drawing located inside the

compartment).

3. Slide in the cover.

4. If the remote control is not

operated for long period of times,

batteries should be discarded.

Remote control instructions

1. The signal reach distance of the

remote control to the receiver that

is inside the main unit of the air

conditioner is 8 meters. Any

obstruction placed between the

receiver and the remote control

can cause interference, limiting

the capacity of the programming.

2. Any time that a button is pressed

in the remote control, the air

conditioner emits a “beep” that

indicates that a command has

been received and transmitted in

the indoor unit.

1. When replacing batteries, do not

use old batteries or a different type

battery. This may cause the remote

control to malfunction.

2. If you do not use the remote

controller for several weeks remove

the batteries. Otherwise battery

leakage may damage the remote

controller.

3. The average battery life under

normal use is about 6 months.

4. Replace the batteries when there is

no answering beep from the indoor

unit or if the Transmission Indicator

light fails to light.

3. When selecting the function of

timer, the remote control sends

(automatically) a signal to the indoor

unit at the specific moment. If the

control remote is left in a position

that the signal is blocked, a 15

minute delay can be produced.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare