
47
Cash-Card
Inserting the Cash-Card
Insert the Cash-Card with the
-symbol facing
up wards. In the display will appear in succession the
amount stored on the Cash-Card, the amount on
account which will be deducted, as well as the new
Cash-Card balance. Any remaining credit balance stored
in the machine will be set off.
If the amount available on the CashCard is not suf-
cient
for the wash, a signal will sound and the message
«Balance too small» appears. The difference can be set-
tled with a second Cash-Card.
Removing the Cash-Card
Selecting and starting the wash programme
see chapter «Washing/Selecting the wash programme»)
X Select the washing programme
X Select additional functions
X Start the programme
Displays during the programme sequence
During the washing programme, the remaining time and
the remaining credit balance are displayed alternately.
Programme end
When the drying programme is completed, the remai ning
amount is stored in the machine under the appropriate
Cash-Card. This remaining credit balance will be set off
at the next washing cycle. The program me end is dis-
played by the display value 00:00h as well as the message
«Open door».
Re-crediting
Re-crediting of the remaining credit balance is best
made at the end of a washing day.
X Insert the Cash-Card. The amount stored on the
Cash-Card will appear in the digital display.
X Re-credit by pressing the Quick Wash button. On the
display will appear in sequence the remaining credit
balance which will be credited, as well as the new Cash-
Card balance.
X Remove the Cash-Card.
Re-crediting can always be made only to that Cash Card
from which the amount was originally deducted.
In the case of child lock switched on:
+
Remaining value transfer
If there is not an adequately high remaining amount
available on a Cash-Card to pay for the booking on ac-
count, a signal will sound and the message «Balance too
small» appears. By inserting a second Cash Card, the
difference can be paid.
Problems
Repairs, alterations or intervention on electronic equip-
ment should only be carried out by qualied specialists.
Inexpert repairs can cause considerable damage and risk
to the user.
Only original spare parts should be used for repairs.
Please nd below minor faults which you can rectify
yourself.
Error messages on the display
If the following error messages are displayed, the pro-
gramme can be restarted by pressing the start button
once the error has been rectied.
«CHILD LOCK ACTIVE»
X Hold the Quick Wash button down and press the
Start button.
«PLEASE CLOSE DOOR»
X Push the door closed until the lock catches properly.
«PLEASE START AGAIN»
If the door was closed subsequently, the Start button
must be pressed again.
After a power failure you must press the Start button
«CHECK WATER SUPPLY»
X Turn on the tap and start again.
X Filter in water supply is blocked: Clean the lter, see
chapter «Cleaning and Maintenance/Cleaning the lter
in the water inlet».
X Interruption in water supply.
«CHECK DRAIN»
X Check whether the drainage hose is blocked.
X Foreign bodies block the drain pump: clean pump
according to chapter «Cleaning and Maintenance/Emer-
gency emptying».
X The water drain provided by the customer is blocked:
Carry out an emergency discharge according to chapter
«Cleaning and Maintenance» and clean the drain si-
phon (built-in siphon).
X The position of the drain hose is too high. The maxi-
mum
pumping height is 1m above ground.
«UNBALANCE NO SPINNING»
X Excessive imbalance. Laundry not spun.
X Press the start button and then the Quick Wash button
to end the wash programme.
X Open the door and redistribute the load.
X Repeat the spin cycle with the separate spin programme.
General information:
X Avoid loading the drum with one single heavy item.
Wash large and small laundry together.
«FOAM PROG. EXTEND»
X The washing machine has detected foam and taken
adequate measures. The spinning cycle of the laundry
could be completed.
In future, please reduce the detergent quantity.
«FOAM, PROG. CANCEL»
X Due to extremely intensive foaming, the washing
machine could not complete the spinning cycle and the
wash programme had to be aborted.
X Repeat the wash programme without adding any
detergent.
Kommentare zu diesen Handbüchern