Electrolux EWS106110W Bedienungsanleitung PDF herunterladen (Seite 22)

Caution! Never place cardboard, wood

or similar materials under the machine to

compensate for any unevenness in the

floor.

Water inlet

Warning! This appliance must be

connected to a cold water supply.

1. Connect the water inlet hose supplied

with the machine to a tap with a 3/4"

thread. Always use the hose supplied

with the appliance.

Important! Do not use the hose from

your previous machine to connect to the

water supply.

2. The other end of the inlet hose which

connects to the machine can be turned

as showed in the picture.

Do not place the inlet hose downwards.

Angle the hose to the left or right depend-

ing on the position of your water tap.

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet hose,

be sure to tighten the ring nut again to

prevent leaks.

The inlet hose must not be lengthened. If it is

too short and you do not wish to move the

tap, you will have to purchase a new, longer

hose specially designed for this type of use.

Important! Before connecting up the

machine to new pipework or to pipework that

has not been used for some time, run off a

reasonable amount of water to flush out any

debris that may have collected in the pipes.

Water drainage

The end of the drain hose can be positioned

in three ways.

• Hooked over the edge of a sink using

the plastic hose guide supplied with the

machine. In this case, make sure the end

cannot come unhooked when the ma-

chine is emptying. This could be done by

tying it to the tap with a piece of string or

attaching it to the wall.

22 electrolux

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare