Electrolux 65557 G-M Wartungshandbuch PDF herunterladen (Seite 15)

15

Adaptation to different types of gas

A. Injectors replacement

• Remove the pan supports.

• Remove the burner's caps and crowns.

• With a socket spanner 7 unscrew and

remove the injectors (Fig. 1), and replace

them with the ones required for the type

of gas in use (see table: Gas Burners).

• Reassemble the parts, following the same

procedure backwards.

• Replace the rating label (placed near the

gas supply pipe) with the relevant one for

the new type of gas supply. You can find

this label in the package of the injectors

supplied with the appliance.

Should the feeding gas pressure be

different or variable compared with the

required pressure, an appropriate pressure

adjuster must be fitted on the gas supply

pipe, in compliance with the rules in force.

B. Adjustment of minimum level

To adjust the minimum level of the

burners, proceed as follows:

• Light the burner.

• Turn the knob on the minimum position.

• Remove the knob.

• With a thin screwdriver, adjust the by-

pass screw positioned in the centre of the

gas tap control shaft (see Fig. 2). If

changing from natural gas 20 mbar and

13 mbar to liquid gas, completely tighten

the adjustment screw in. If changing

from liquid gas to natural gas 20 mbar,

undo the by-pass screw about 1/4 of a

turn. If changing from natural gas 20

mbar to natural gas 13 mbar undo the

by-pass screw about 1/4 of a turn. If

changing from liquid gas to natural gas

13 mbar, undo the by-pass screw about

3/4 of a turn.

• Finally check the flame does not go out

when quickly turning the knob from the

maximum position to the minimum

position.

)

)

This procedure can easily be carried out,

anyhow the hob has been positioned or built

in the working top.

Minimum adjustment screw

Fig. 1

Fig. 2

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare