Electrolux EHG682B Bedienungsanleitung PDF herunterladen (Seite 12)

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

 put the seals supplied with the hob, on the

edges of the cut out: place them exactly on

the front and rear edge and at 50 mm. from

the side edges, taking care that the seals

meet without overlapping;

 place the hob in the cut out, taking care that

it is centred;

 fix the hob with the relevant fixing clamps and

screws, as shown in the diagram. When the

screws have been tightened, the excess seal

can be removed.

The edge of the hob forms a double seal which

prevents the ingress of liquids.

FO 0199

a) Sealing gasket

Electrical connections

Any electrical work required to install this hob

should be carried out by a qualified electrician

or competent person, in accordance with the

current regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability should these

safety measures not be observed.

This hob is designed to be connected to a 230-240V

50Hz AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this book.

The hob is supplied with a 3 core flexible supply cord

incorporating a 3amp plug fitted. In the event of having

to change the fuse, a 3amp ASTA approved (BS 1362)

fuse must be used.

Should the plug need to be replaced for any reason,

the wires in the mains lead are coloured in accordance

with the following code:

Green and Yellow - Earth

Blue - Neutral

Brown - Live

 Connect the green and yellow (earth) wire to

the terminal in the plug which is marked with

the letter 'E' or the earth symbol or

coloured green and yellow.

 Connect the blue (neutral) wire to the terminal

in the plug which is marked with the letter 'N'

or coloured black.

 Connect the brown (live) wire to the terminal

in the plug which is marked with the letter 'L'

or coloured red.

Upon completion there must be no cut, or stray strands

of wire present and the cord clamp must be secure

over the outer sheath.

Permanent Connection

In the case of a permanent connection, it is necessary

that you install a double pole switch between the hob

and the electricity supply (mains), with a minimum gap

of 3 mm. between the switch contacts and of a type

suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth

cable at any point.

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

A cut off plug inserted into a 13 amp socket

is a serious safety (shock) hazard. Ensure

that the cut off plug is disposed of safely.

Min. size Cable/flex Cable / flex type Fuse

0.75 mm

H05 V2V2-F (T90) 3 A

Supply cable replacement

The cable used to connect the hob to the electrical

supply must comply to the specifications given below.

FO 0390

1 2 ... 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux EHG682B Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Electrolux EHG682B