
14 electrolux
Installation Instructions
1 Safety instructions
Warning! This must be read!
The laws, ordinances, directives and stand-
ards in force in the country of use are to be
followed (safety regulations, proper recycling
in accordance with the regulations, etc.)
Installation may only be carried out by a qual-
ified electrician.
The minimum distances to other appliances
and units are to be observed.
Anti-shock protection must be provided by
the installation, for example drawers may
only be installed with a protective floor direct-
ly underneath the appliance.
The cut surfaces of the worktop are to be
protected against moisture using a suitable
sealant.
The sealant seals the appliance to the work
top with no gap.
When building in, protect the underside of
the appliance from steam and moisture, e.g.
from a dishwasher or oven.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-
ware may be knocked off the rings when
doors and windows are opened.
Distance from the wall: at least 50 mm.
z Risk of injury from electrical cur-
rent.
• The appliance must be free of voltage
when installing and uninstalling.
• Observe connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection through
correct installation by a qualified install-
er.
• The appliance must be connected to the
electrical supply by a qualified electri-
cian.
z Risk of injury from electrical cur-
rent.
Loose and inappropriate plug and socket
connections can make the terminal over-
heat.
• Have the clamping connections correct-
edly installed by a qualified electrician.
• Use strain relief clamp on cable.
• This appliance’s mains cable is fixed di-
rectly to the board. If the mains cable is
damaged, it must only be replaced by a
qualified ecletrician or our Customer
Care Department.
A device must be provided in the electrical
installation which allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm.
Suitable isolation devices include line pro-
tecting cut-outs, fuses (screw type fuses are
to be removed from the holder), earth leak-
age trips and contactors.
Kommentare zu diesen Handbüchern