Electrolux EHP60040K Bedienungsanleitung Seite 7

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 48
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 6
3. At the end rub the appliance dry
with a clean cloth.
TROUBLESHOOTING
Problem Possible cause Remedy
You cannot activate or operate
the appliance.
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
Check if the appliance is cor-
rectly connected to the electri-
cal supply (refer to connection
diagram).
Problem with the house electri-
cal system.
Examine the fuse in the electri-
cal system of the house in the
fuse box. If the fuses blow
again and again, speak to
qualified electrician.
The residual heat indicator
does not come on.
The cooking zone is not hot
because it operated only for a
short time.
If the cooking zone operated
sufficiently long to be hot,
speak to the service centre.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the Customer Care Department. Give the
data from the rating plate, three-digit-letter
code for the glass ceramic (it is in the cor-
ner of the cooking surface) and an error
message that comes on.
If you operated the appliance incorrectly,
the servicing by a customer service techni-
cian or dealer will not be free of charge,
even during the warranty period. The in-
structions about the customer service and
conditions of guarantee are in the guaran-
tee booklet.
INSTALLATION
Warning! Refer to the Safety chapters.
Before the installation, note down
the serial number (Ser. Nr.) from the
rating plate.The rating plate of the
appliance is on its lower casing.
EHP60040K
949 594 077 01
58 PEE 01 AO
ELECTROLUX
220-240 V 50-60 Hz
6,0 kW
BUILT-IN APPLIANCES
Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
CONNECTION CABLE
Use the correct mains cable of type
H05BB-F Tmax 90°C (or higher) for a sin-
gle phase or two phase connection.
Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C
or higher). Speak to your local Service
Centre.
electrolux 7
Seitenansicht 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare