
7
Connection of child safety
device on zones
Turn the 2 control buttons to
at the same time.
The display will show:
When you turn on a zone the display
will show:
To turn on a zone, turn the 2 control
buttons to at the same time. You
must then activate one of the zones
within 10 seconds.
The light under the symbol in the
display will disappear.
You can disconnect the child safety
device permanently as follows:
1. Turn the 2 control buttons to and
return to 0.
2. Turn one of the 2 control buttons
immediately to .
S A
F E
Before use
22
The electrical connection may only be
performed by a qualified electrician/
competent person. The electrical
connection must be carried out in
accordance with prevailing regulations
for appliances using heavy current.
The connection must comply with any
specific requirements specified by the
local electricity supply authority.
There must be no interference with
any of the unit’s electrical parts.
The cable is mounted in the pegs as
shown.
Unscrew the cover while connecting
the cables.
A unit led directly to the power point
or the outlet rose.
More units may be connected via one
or more junction boxes.
The cable must be connected via an
external switch with a contact
separation of at least 3 mm in each
pole.
Please observe these instructions,
otherwise the warranty will not
cover any damage that may occur.
Two-phase zero-earth (2x16 A)
Cable type 1,5 mm² HO5VV-F.
The cable outside diameter must be
between 7,5 and 10,5 mm.
Electrical installation
Kommentare zu diesen Handbüchern