Electrolux EHP740X Bedienungsanleitung Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 14
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
9
Switch symbols (to the left)
control for regulating the small
cooking zone at the rear
control for regulating the double
cooking zone at the front.
control for regulating the large
cooking zone at the rear
control for regulating the small
cooking zone at the front.
Regulating
The regulation of heat is step-free for all
plates on a scale from 1 to 9.
1 Represents lowest heat
9 Represents maximum heat.
0 Represents OFF.
Double cooking zone
Small circle: When you control on the
cooking section it will always be the
small circle that is controled on. Choose
the wanted temperature.
From small to big circle (both circles
are on): Turn the button past 0. Turn
back to the wanted temperature.
From big to small circle: Turn the
button back to 0. Control on again and
choose the wanted temperature.
How to use
20
Minimum distance
to wall:
150 mm
Minimum distance
to wall (non-
flammable material):
50 mm
Reinforcement
beams
Mounting
Caution: In order to avoid a hazard this
appliance must be installed according to
these instructions for installation
The appliance unit can be mounted in
any type of kitchen with a work top
whose thickness is between 28 mm and
40 mm.
Clearance
The distance between the top side of the
work top and the carpentry underneath
must be at least 47 mm.
Fixing
Screw the fixing brackets out to such an
extent that they can be turned in under
the work top. Tighten the brackets on to
the work top with an ordinary
screwdriver.
Cut-out measurements
One rectangular hole is sawn out for the
appliance combination chosen.
The depth of the cut-out for any unit is:
490 mm
Length of hole = sum of all units`
externally measured length, less 20 mm.
Mounting of Reinforcement
Beams
A reinforcement Beam, with supporting
flanges at each end, is included with
each two-burner unit. For unit
combinations, a reinforcement beam
must be used between each unit.
Min. 47 mm
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare