Electrolux EKM6035 Bedienungsanleitung PDF herunterladen (Seite 23)

electrolux 23

Ignition electrodeIgnition electrode

Ignition electrodeIgnition electrode

Ignition electrode

The electric ignition is obtained

through a ceramic "electrode" and a

metal electrode. Keep these components

well clean, to avoid difficult lighting, and

check that the burner crown holes are not

obstructed.

The HotplateThe Hotplate

The HotplateThe Hotplate

The Hotplate

Spills onto the actual plate should be

removed using warm water and a soft

brush, nylon or plastic scourer. To keep

the plate looking as new, hotplate

conditioner can be purchased from

most hardware stores (follow the

manufacturer's instruction for use).

Alternatively, wipe the plate with a

drop of olive oil on a kitchen towel to

avoid rust. It is important to note that the

plate will smoke a little and produce a

slightly unpleasant odour when next

used

DryingDrying

DryingDrying

Drying

Important: After cleaning, dry the

hotplate thoroughly by switching on to

a low-medium setting for a few minutes.

Before any maintenance or

cleaning can be carried out, you

must DISCONNECT the appli-

ance from the electricity supply.

This appliance cannot be

cleaned with steam or with a

steam cleaning machine.

The Hob TThe Hob T

The Hob TThe Hob T

The Hob T

opop

opop

op

The hob is best cleaned whilst it is still

warm, as spillage can be removed more

easily than if it is left to cool.

Regularly wipe over the hob top using

a soft cloth well wrung out in warm water

to which a little wasing up liquid has been

added. Avoid the use of the following:

- household detergent and bleaches;

- impregnated pads unsuitable for non-

stick saucepans;

- steel wool pads;

- bath/sink stain removers.

Should the hob top become heavily

soiled, it is recommended that a cleaning

product such as Hob Brite or Bar Keepers

Friend is used.

Pan SupportsPan Supports

Pan SupportsPan Supports

Pan Supports

The pan supports are dishwasher

proof. If washing them by hand, take care

when drying them as the enamelling

process occasionally leaves rough

edges. If necessay, remove stubborn

stains using a paste cleaner.

The BurnersThe Burners

The BurnersThe Burners

The Burners

The burner caps and crowns can be

removed for cleaning.

Wash the burner caps and crowns

using hot soapy water, and remove

marks with a mild paste cleaner. A well

moistened soap impregnated steel wool

pad can be used with caution, if the

marks are particularly difficult to remove.

After cleaning, be sure to wipe dry

with a soft cloth.

Maintenance and Cleaning

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 36 37

Kommentare zu diesen Handbüchern

Keine Kommentare