Electrolux EHD60020P Bedienungsanleitung PDF herunterladen (Seite 11)

Problem Possible cause Remedy

The diameter of the bottom of

the cookware is too small for

the cooking zone.

Move cookware to a smaller

cooking zone.

and a number come on.

There is an error in the appli-

ance.

Disconnect the appliance from

the electrical supply for some

time. Disconnect the fuse from

the electrical system of the

house. Connect it again. If

comes on again, speak to the

service centre.

comes on.

There is an error in the appli-

ance because a cookware

boils dry. The overheating pro-

tection for the cooking zones

and the Automatic Switch Off

operate.

Deactivate the appliance. Re-

move the hot cookware. After,

approximately 30 seconds, acti-

vate the cooking zone again. If

the cookware was the problem,

the error message goes out of

the display, but the residual

heat indicator can stay. Let the

cookware become sufficiently

cool and refer to “Cookware for

the induction cooking zone” to

see if your cookware is compat-

ible with the appliance.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance cor-

rectly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer service

and conditions of guarantee are in the guar-

antee booklet.

INSTALLATION

Warning! Refer to the Safety chapters.

Before the installation, note down

the serial number (Ser. Nr.) from the

rating plate.The rating plate of the

appliance is on its lower casing.

EHD60020P

949 594 287 00

58 GAD D5 AU

ELECTROLUX

220-240 V 50-60 Hz

7,4 kW

Induction 7,4 kW

BUILT-IN APPLIANCES

• Only use the built-in appliances after you

assemble the appliance into correct built-

in units and work surfaces that align to

the standards.

CONNECTION CABLE

• The appliance is supplied with the con-

nection cable.

• Replace the damaged mains cable with a

special cable (type H05BB-F Tmax 90°C;

or higher). Speak to your local Service

Centre.

electrolux 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare