
TROUBLESHOOTING
Problem Possible cause Remedy
You cannot activate
the appliance or oper-
ate it.
Activate the appliance again and set the heat
setting in less than 10 seconds.
You touched 2 or
more sensor fields at
the same time.
Touch only one sensor field.
The STOP+GO func-
tion operates.
Refer to the chapter “Daily Use”.
There is water or fat
stains on the control
panel.
Clean the control panel.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the ap-
pliance is deactivated.
You put something on
one or more sensor
fields.
Remove the object from the sensor fields.
The appliance deacti-
vates.
You put something on
the sensor field
.
Remove the object from the sensor field.
The residual heat indi-
cator does not come
on.
The cooking zone is
not hot because it op-
erated only for a short
time.
If the cooking zone operated sufficiently long to
be hot, speak to the service centre.
The Automatic Heat
Up function does not
operate.
The cooking zone is
hot.
Let the cooking zone become sufficiently cool.
The highest heat set-
ting is set.
The highest heat setting has the same power as
the Automatic Heat Up function.
The heat setting
changes between two
levels.
The Power manage-
ment is activated.
Refer to “Power management”.
The sensor fields be-
come hot.
The cookware is too
large or you put it too
near to the controls.
Put large cookware on the rear cooking zones if
necessary.
There is no signal
when you touch the
panel sensor fields.
The signals are deacti-
vated.
Activate the signals. Refer to “OffSound control”.
comes on
The Automatic Switch
Off operates.
Deactivate the appliance and activate it again.
comes on
There is no cookware
on the cooking zone.
Put cookware on the cooking zone.
The cookware is incor-
rect.
Use the correct cookware.
The diameter of the
bottom of the cook-
ware is too small for
the cooking zone.
Use cookware with correct dimensions.
electrolux 11
Kommentare zu diesen Handbüchern