Electrolux EHG6415 Bedienungsanleitung PDF herunterladen (Seite 15)

• Use the correct mains connection cable

and replace the damaged mains cable

with applicable cable. Speak to your local

Service Force Centre.

• The appliance must have the electrical in-

stallation which lets you disconnect the

appliance from the mains at all poles with

a contact opening width of minimum 3

mm.

• If the fixing bracket is near to the terminal

block, always make sure the connection

cable does not come in contact with the

edge of the bracket.

• You must have correct isolation devices:

line protecting cut-outs, fuses (screw

type fuses removed from the holder),

ground leakage trips and contactors.

Disposal of the appliance

• To prevent the risk of physical injury or

damage

– Disconnect the appliance from the

power supply.

– Cut off the mains cable where it con-

nects with the appliance and discard it.

– Flat the external gas pipes if there are

fitted.

– Speak to your local authorised facilities

for disposal of your appliance.

INSTALLATION

Warning! The following instructions

about installation, connection and

maintenance must be carried out by

qualified personnel in compliance with

standards and local regulations in

force.

Gas Connection

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not come

in touch with mobile parts or they are not

squeezed. Also be careful when the hob is

put together with an oven.

Important! Make sure that the gas supply

pressure of the appliance obeys the

recommended values. The adjustable

connection is fixed to the comprehensive

ramp by means of a threaded nut G 1/2".

Screw the parts without force, adjust the

connection in the necessary direction and

tighten everything.

1

2

2

3

4

1 End of shaft with nut

2 Washer (additional washer is only for

Slovenia and Turkey)

3 Elbow

4 Rubber pipe holder for liquid gas (only

for Slovenia and Turkey)

Flexible nonmetal pipes connection:

If it is possible to easily control the connec-

tion in its full area, you can use a flexible

pipe. Tightly attach the flexible pipe by

clamps.

Liquid gas: use the rubber pipe holder. Al-

ways engage the gasket. Then continue

with the gas connection. The flexible pipe is

prepared for apply when:

electrolux 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare