Electrolux EHS7780K Bedienungsanleitung PDF herunterladen (Seite 27)

65

Electrical connection

The appliance is designed to be connected

to 220 V monophase electricity supply.

The connection must be carried out in

compliance with the laws and regulations in

force.

Before the appliance is connected:

1. check that the main fuse and the

domestic installation can support the

load (see the rating label);

2. check that the power supply is properly

earthed in compliance with the current

rules;

3. check the socket or the double pole

switch used for the electrical connection

can be easily reached with the appliance

built in the forniture unit.

The appliance is supplied with a connection

cable and the relevant plug.

The plug has to be fitted in a proper socket.

If connecting the appliance directly to the

electric system, it is necessary that you

install a double pole switch between the

appliance and the electricity supply, with a

minimum gap of 3 mm. between the switch

contacts and of a type suitable for the

required load in compliance with the current

rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

temperature higher than 90°C.

The brown coloured phase cable (fitted in the

terminal block contact marked with "L")

must always be connected to the network

phase.

Neutral

Earth (yellow/green)

Replacing the power cable

When replacing the cable, only use

H05V2V2-F (T90) type cables suitable for

the load and working temperature. Also, the

yellow/green earth wire must be about 2 cm

longer than the phase and neutral wires (see

figure).

After connection, test the heating elements

by switching them on for about 3 minutes.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare