Electrolux GHGL4046CN Installationshandbuch PDF herunterladen (Seite 8)

CAUTION!

Do not stretch the seal.

Cut the pieces of the

right size.

3. Put the hob back on the cooking

surface and adjust the burners. Make

sure that the hob does not rise above

the surrounding worktop surfaces.

Make the final check whether the

appliance functions correctly and the gas

installation is safe.

B) Installation onto the worktop

1. Prepare a cut-out in the worktop

according to the dimensions shown

on the pictures 1 and 2. Do not

exceed the tolerance margin.

Picture 1

2. Carefully clean the worktop around

the cut-out and the cut-out edges.

3. The rubber seal (A) has to be glued

onto the surface where the worktop

and the hob touch to prevent

vibrations and protect the glass

against mastic.

Picture 2

A

B

4. Make sure to install the oven and the

burners according to the installation

instructions.

5. Place the glass hob carefully in the

cut-out and then level it making

allowance for the seal around the

edges. As the actual dimensions of

the glass hob and the cutout may

vary, the size of the joint also can be

different by minimum 2 mm.

6. Place the burner cap, burner crown

and the round profile onto burner

base so the ignition candles and

thermocouples extend through their

respective holes. Push the burner

head down firmly until it clicks into its

place correctly.

7. Secure the round profiles, with 2

screws each, onto the burners in the

cooking surface. In this way the hob

is secured to the worktop.

8. Put in place and adjust the burner

crowns and the burner caps. Place

the pan supports in the appropriate

indentations.

Make the final check whether the

appliance functions correctly and the gas

installation is safe.

www.electrolux.com8

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare