
Problem Possible cause Remedy
The residual heat indicator
does not come on.
The cooking zone is not hot
because it operated only for a
short time.
If the cooking zone operated
sufficiently long to be hot, speak
to the service centre.
The Automatic Heat Up func-
tion does not operate.
The cooking zone is hot. Let the cooking zone become
sufficiently cool.
The highest heat setting is set. The highest heat setting has the
same power as the Automatic
Heat Up function.
You cannot activate the outer
ring.
Activate the inner ring first.
The sensor fields become hot. The cookware is too large or
you put it too near to the con-
trols.
Put large cookware on the rear
cooking zones if necessary.
There is no acoustic signal
when you touch the panel sen-
sor fields.
The signals are deactivated. Activate the signals (refer to
“OffSound Control”).
comes on.
The Automatic Switch Off op-
erates.
Deactivate the appliance and
activate it again.
comes on.
The Child Safety Device or the
Lock function operates.
Refer to the chapter “Daily Use”.
and a number come on.
There is an error in the appli-
ance.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service center.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
INSTALLATION INSTRUCTIONS
Warning! Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Warning! During installation in
combustible matter, NIN SEV 1000 and
fire protection guidelines and
regulations of the Association of
Cantonal Fire Insurance shall be strictly
adhered to.
BUILT-IN APPLIANCES
• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
electrolux 11
Kommentare zu diesen Handbüchern