4
When the appliance is not in use
Disconnect the appliance from the electricity supply. Empty all
foods and clean the appliance, leaving the doors ajar to prevent
unpleasant smells.
The light bulb
The opening on the diffuser gives access to the light bulb.
If the light does not come on when the door is opened, check that
the bulb is screwed in properly; replace the bulb if the fault
persists.
The rating is shown on the light bulb cover.
Something not Working
Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions:
Level properly the appliances if it is not well levelled.
Weight surpasses the storage limit of the door shelf so spread weight more evenly or
take some products out.
Readjust the door if it is not properly aligned.
Set a lower temperature.
Distribute the food products to allow cold air to circulate around them.
Make sure that the door is completely closed and that the insulating strip is complete
and clean.
The temperature where the cabinet is placed is above normal room temperature.
Set a warmer temperature.
Turn the thermostat knob to a lower number
The temperature where the cabinet is placed is above normal room temperature.
Check that the ventilation is sufficient and that the ventilation openings are unobstructed.
The cause could be the introduction of large quantities of food and/or frequent
opening/closing of the door.
Sometimes this is normal. Temperature control may cause clicking sounds when the
system is connected or disconnected.
The injected cooling gas may produce a gurgling sound while passing through the tubes.
The motor may cause a humming noise and/or slight bumping.
The insulation material used has a tendency to slighly increase noise levels, how ever it
allows for much better insulation and a lower energy consumption.
Door do not close
It is too warm inside the refrigerator
It is too cold inside the refrigerator.
The compressor works continuously.
Noises
SYMPTOM SOLUTION
Customer service and spare parts
If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service
department and consult the Guarantee card. Selective ordering of replacement parts can save unnecessary travel and costs. For this
reason always provide the following appliance information:
- Model Name
- Model Number (PNC)
- Serial Number (S-No.)
This information can be found on the rating plate inside the cabenit on the left hand wall. We recommend that you enter this information
here, so that it is handy if needed.
Kommentare zu diesen Handbüchern