Electrolux ERT1372 Bedienungsanleitung PDF herunterladen (Seite 6)

5. Unscrew bottom hinge (E) and part (F) and reÞt them on the

opposite side.

6. Unscrew the handle (D)

. Refit it on the opposite side after

having pushed in the plugs with a punch. Cover the holes left

open with the plugs contained in the documentation pack.

Warning!

If the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket or accelerate this

process by heating up the part involved with a normal

hairdrier.

Building the appliance in

under a worktop

This appliance can also be built in under the worktop of your

kitchen unite. To do this, proceed as follows:

1. remove screws which secure the top to the rear brackets;

2. move the top slightly to release it from the retainers and remove

it;

3. unscrew the screws securing the rear feet to the cabinet;

4. remove the 3 mm shim from the feet and refit them; screw in the

front feet to obtain the required height.

Important

For the appliance to function properly, an opening of at

least 137 cm

must be cut in the kitchen worktop (see fig.).

A minimum clearance must also be provided between

the,condenser and the wall, as shown in the figure.

Attention!

It must be possible to disconnect the appliance from the

mains power supply; the plug must therefore be easily

accessible after installation.

1 2 3 4 5 6 7

Keine Kommentare

Electrolux ERT1372 Bedienungsanleitung Seite 6