Electrolux ESF246KING Bedienungsanleitung PDF herunterladen (Seite 3)

Positioning and installation

Positioning

In its standard version the machine is intended for

installation on a kitchen sink or worktop. To function

properly the machine must be fully level. Its height

can be adjusted with the adjustable feet (8 mm each).

Water supply

The temperature of the water supply should not exceed

65°C and the pressure should be between 50-1000 kPa

(0.5-10 kp/cm

). It is important to have a tap or stopcock,

positioned close to the machine and with easy access.

Special mixer taps with dishwasher connections are

available, as well as adaptors for older mixer taps.

Insert the combination rubber washer/filter and connect

the inlet hose to a tap with a 3/4" pipe thread.

The inlet hose (1) must not be joined onto any form of

extension hose. If it is too short, the entire hose must

be replaced with a longer high-pressure hose, specially

designed for the purpose. The machine end of this hose

can be turned in any direction. Loosen the retaining nut,

turn the hose, then retighten the nut.

Discharge connection

Connect the discharge hose to the pipe stub at the rear

of the dishwasher, using the hose clip supplied. It is

important to push the discharge hose (2) onto the pipe

stub as far as it will go and tighten the hose clip (3) as

hard as possible. Place the other end of the discharge

hose over the sink as illustrated.

The discharge hose must not at any point rise higher than

the top of the dishwasher. If it runs higher, operation of

the dishwasher might be impaired. It is also important

to ensure that the inside diameter of the hose is not less

than 13 mm at any point. If the discharge hose is too

long it can easily be cut to the right length.

- Cut the hose to a suitable length, using a sharp knife.

- Fit the elbow supplied onto the end of the hose.

Electrical connection

The dishwasher must be connected to an earthed wall

socket which must be easily accessible and protected

by a 10 Amp fuse. Permanent electrical installation must

be carried out by an authorised electrician. Before any

work is carried out on the machine it must be isolated

from the electric mains supply, for example by removing

the plug from the wall socket.

- 11 -

1 2 3 4 5 6 7 8 ... 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux ESF246KING Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Electrolux ESF246KING