Electrolux EXS24HS2WE Bedienungsanleitung PDF herunterladen (Seite 9)

1. For the left-hand and right-hand piping, remove the pipe cover from the side panel.

2. For the rear-right-hand and rear-left-hand piping, install the piping as shown. Bend the

connecting pipe to be laid at a height of 43mm or less from the wall.

3. Fix the end of the connecting pipe. (Refer to Tightening Connection in REFRIGERANT

PIPING CONNECTION)

Connecting pipe

Indoor unit outline

Connecting pipe

1. Pass the piping through the hole in the wall.

2. Put the upper claw at the back of the indoor unit on

the upper hook of the installation plate, move the

indoor unit from side to side to see that it is securely

hooked.

3. Piping can easily be made by lifting the indoor unit

with a cushioning material between the indoor unit

and the wall. Remove cushioning material after finish

piping.

4. Push the lower part of the indoor unit up on the wall,

Then move the indoor unit from side to side, up and

down to check if it is hooked securely.

Fig.10

4. Indoor unit installation

Fig.8

Fig.9

3. Connecting Pipe and Drainage Installation

1. Run the drain hose sloping downward. Do not install the drain hose as illustrated below.

2. When connecting an extension drain hose, insulate the connecting part of the extension

drain hose with a shield pipe, do not let the drain hose become slack.

Fig.7

Right-hand piping

Side Part cover

Left-hand piping

Rear-right piping

Rear-left piping

Do not block water flow with a rise.

Do not put the end of the

drain hose into water.

Upper Hook

Lower Hook

Cushioning

material

INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

Electrolux EXS24HS2WE Bedienungsanleitung Seite 9