Electrolux EUN12310 Bedienungsanleitung

user manualFreezerEUN12310

5. Make sure the electricity supply voltageis the same as that indicated on the ap-pliance rating plate.6. Switch on the appliance.The appliance is su

1. If necessary cut the adhesive sealingstrip and then apply it to the applianceas shown in figure.xx2. Install the appliance in the niche.Push the ap

5. Remove the correct part from the hingecover (E). Make sure to remove the partDX, in the case of right hinge, SX in op-posite case.6. Attach the cov

10. Open the appliance door and the kitch-en furniture door at an angle of 90°.Insert the small square (Hb) into guide(Ha).Put together the appliance

collection point for the recycling of electricaland electronic equipment. By ensuring thisproduct is disposed of correctly, you willhelp prevent poten

electrolux 15

222352044-A-402010 www.electrolux.com/shop

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Control panel 4First use 5Daily use 5H

damage to the cord may cause a short-circuit, fire and/or electric shock.Warning! Any electrical component(power cord, plug, compressor) mustbe replac

Service• Any electrical work required to do theservicing of the appliance should be car-ried out by a qualified electrician or com-petent person.• Thi

FIRST USECleaning the interiorBefore using the appliance for the first time,wash the interior and all internal accesso-ries with lukewarm water and so

can possibly cause the skin to be freezeburnt;• it is advisable to show the freezing in dateon each individual pack to enable you tokeep tab of the st

3. Leave the door open and insert theplastic scraper in the appropriate seat-ing at the bottom centre, placing a basinunderneath to collect the defros

Problem Possible cause SolutionThe Alarm light flashes. The temperature in the freezer istoo high.Refer to "Excessive TemperatureAlarm"The c

The technical information are situated in therating plate on the internal left side of theappliance and in the energy label.INSTALLATIONRead the "