10 www.electrolux.com
Occurrence Solution
Dehumidier does not operate Wall plug disconnected. Push plug rmly
into wall outlet.
House fuse blown or circuit breaker
tripped. Replace fuse with time delay type
or reset circuit breaker.
The dryness level you selected has been
reached. Dehumidier automatically shuts
off when selected amount of moisture has
been removed from the air. If you want
to remove more moisture, select CON-
TINUOUS by using the humidity button or
knob. After the dehumidier starts, reset
the control to the desired setting.
Bucket not installed properly. See
“Removing Collected Water”.
Water in the bucket has reached its preset
level. Dehumidier automatically turns
off when this occurs. Empty bucket and
return bucket to position.
Dehumidier is not turned on. Turn unit on.
BUCKET FULL light is on. Remove buck-
et, empty water and re-install correctly.
Dehumidier runs too much Windows or doors near dehumidier are
open to outdoors. Close all windows or
doors to outside.
Area to be dehumidied is too large.
Check with your dealer to see if capacity
is adequate.
Air movement through dehumidier is
blocked. Grill may be dirty. Use brush at-
tachment of vacuum cleaner to clean grill.
See “Care and Cleaning“. Dehumidier
must be placed in a space that does not
restrict air owing into the rear coil or out
of the front grill.
Dehumidier has been installed or re-
started recently. The higher the moisture
in the room, the longer the dehumidier
will operate.
Dehumidier is in the CONTINUOUS
mode and will remain on in this mode, use
the humidity button or knob to set a RH%
higher level.
Kommentare zu diesen Handbüchern