Electrolux RC1180 Bedienungsanleitung PDF herunterladen (Seite 5)

Figure 2.

3. Cleaning

Clean both the inside and outside of the

appliance before putting it into use.

To do so, use a soft towel, lukewarm water and a

non-abrasive detergent. Ensure water does not

enter the rear cover grill or the control panel.

Afterwards, wipe the appliance with a clean towel

and clean water, and then wipe it dry.

To avoid damage, do not use soap, soda or

abrasive cleaners.

4. Positioning the appliance

During the refrigeration process, the appliance

gives off heat from the condenser (under the

upper part of the rear cover) into the surrounding air.

The more ventilated the condenser is, the more

effective the refrigeration will be.

For maximum performance the appliance must be

level at all times when operating. If the appliance is

operating in a moving vehicle, the amount of the

refrigeration will be slightly less than if the appliance

is level in a stationary position.This is caused by the

movement of the vehicle impairing the flow of the

refrigerant within the unit.

It is important that the appliance is not directly

exposed to radiated heat (sunlight, radiator, near an

oven, etc.).

In gas operation following clearances should be

kept from the walls or other materials: from the

back side of the appliance minimum 10 cms, from

the both sidewalls minimum 4 cms each, from the

top of the appliance minimum 30 cms , from the

bottom minimum 5 cms.

In the immediate vicinity of the appliance within the

specified distances no inflammable matters (paper,

wodd, grass, textile, etc.) should be met with.

5. Using the appliance

The cable for mains connection, the 12V connection

and the gas inlet are located on the rear cover of the

RC1180 (Figure 2).

5.1. Operating from electrical mains

Make sure the voltage shown on the data plate of the

appliance matches that of the mains voltage to which

you wish to connect the appliance. Pull out the mains

connecting cable and connect it to a receptacle

earthed socket for connection.

When connecting the appliance for the first time, set

the thermostat to maximum; then, after about five

hours, set it back towards minimum, according to your

cooling needs.

NB: Plug is provided according to specific

regulations in each country and may be different to

that shown.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux RC1180 Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Electrolux RC1180