Electrolux EXD16DN3W Bedienungsanleitung PDF herunterladen (Seite 7)

7 ENGLISH

• Make sure to direct airow at the wet

clothes shown as picture below.

• For thick and heavy wet clothes may

not get the best effective dehumidica-

tion.

CAUTION!

• Do not cover the air outlet of the

unit with clothes. It may cause

excessive heat, re or failure

of unit.

• Do not place the wet clothes on

the top of the unit and do not

make the water drop into the

unit. It may cause electric shock,

creepage or failure of unit.

4.8 How to Use Timer Function

The TIMER function enables you to ei-

ther Delay Start or Delay Stop the unit in

the choice from 0.5 hour to 24 hours.

When the unit is on, rst press the Timer

button, the Timer Off indicator light il-

luminates. It indicates the Auto Stop pro-

gram is initiated. Press it again the Time

On indicator light illuminates. It indicates

the Auto Start is initiated.

Press or hold the

or pad to change

the Auto time by 0.5 hour increments, up

to 10 hours, then at 1 hour increments up

to 24 hours. The control will count down

the time remaining until start.

The selected time will register in

5 seconds and the system will automati-

cally revert back to display the previous

humidity setting.

When the Auto start & Auto stop times

are set, within the same program se-

quence, TIMER ON OFF indicator lights

illuminate identifying both ON and OFF

times are now programmed.

Turning the unit ON or OFF at any time

or adjusting the timer setting to 0.0 will

cancel the Auto Start/Stop function.

When LED display window displays the

code of P2, the Auto Start/Stop function

will also be cancelled.

NOTE:

• Before entering TIMER setting, make

sure power is being supplied to the unit.

• Before entering TIMER setting, make

sure pressing HUMIDITY or button

sets one desired room humidity rst.

4.9 Fault Codes

AS- Humidity sensor error--Unplug the

unit and plug it back in. If error repeats,

call for service.

ES- Temperature sensor error-- Unplug

the unit and plug it back in. If error re-

peats, call for service.

P1- Unit is defrosting-- Allow the unit time

to automatically defrost. The protection

will clear after the unit self defrosts.

P2- Bucket is full or bucket is not in right

position-- Empty the bucket and replace

it in the right position.

E3- Unit malfunction-- Unplug the unit

and plug it back in. If error repeats, call

for service.

EC- Refrigerant leakage detection-- With

this new technology, the display area will

appear EC when the unit detects refriger-

ant leakage,call for service.

4.10 Removing collected water

There are two ways to remove collected

water.

4.11 Use the bucket

When the unit is off, if the bucket is full,

the unit will beep 8 times and the Full

indicator light will ash, the digital display

shows P2.

When the unit is on, if the bucket is full,

the compressor turns off and the fan

turns off after 30 seconds for drying the

water of the condenser, then the unit will

beep 8 times and the Full indicator light

will ash, the digital display shows P2.

Follow the step below to remove the col-

lected water from the bucket:

1 2 3 4 5 6 7 8 9 10 11 12 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare