Electrolux EGC3322NOK Bedienungsanleitung PDF herunterladen (Seite 11)

WARNING!

The following instructions about

installation, maintenance and ven-

tilation must be carried out by

qualified personnel in compliance

with the regulation in force (UNI-

CIG 7129 - 7131). Make sure that

the kitchen is well ventilated: keep

natural ventilation holes open (at

least 100 cm²) or install a me-

chanical extractor hood.

8.1 Gas Connection

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

Make sure that the gas supply

pressure of the appliance obeys

the recommended values. If the

supplied pressure has not the

specified value, it is necessary to

assemble a proper pressure regu-

lator in compliance with the stand-

ard UNI EN 88. For Liquid Gas

(LPG) the use of pressure regula-

tor is allowed only if they are in

compliance with UNI EN 12864.

The adjustable connection is fixed

to the comprehensive ramp by

means of a threaded nut G 1/2".

Screw the parts and tighten ev-

erything with teflon tape, if neces-

sary, to get the right direction.

A

B

C

A)

End of shaft with nut

B)

Washer

C)

Elbow (if needed)

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end) (UNI-

CIG 7129).

Flexible connection:

Use a flexible pipe in stainless steel (UNI-

CIG 9891) with a maximum length 2 m.

When installation is complete,

make sure that the seal of each

pipe fitting is correct. Use a soapy

solution, not a flame!

8.2 Injectors replacement

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Techni-

cal Information" chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.3 Adjustment of minimum level

To adjust the minimum level of the burn-

ers:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the by-

pass screw position.

A

A)

The by-pass screw

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare