Electrolux EOB7S31Z Bedienungsanleitung PDF herunterladen (Seite 41)

3. Touch or to select a cleaning

function.

4. Touch to confirm.

12.6 Tank Emptying - S1

Remove all accessories.

The cleaning function removes the

residual water from the water drawer.

Use the function after the steam cooking

function.

The duration of the function is around 6

minutes.

The light in this function is off.

1. Put the tray on the first shelf position.

2. Activate Tank Emptying function -

S1. Refer to "Activating a cleaning

function".

3. Touch .

Remove the baking tray after the end of

the procedure.

12.7 Steam Cleaning - S2

Remove as much dirt as possible

manually.

Remove the accessories and the shelf

support to clean the side walls.

The steam cleaning functions support the

steam cavity cleaning of the appliance.

For a better performance

you should start the cleaning

function when the appliance

is cool.

The specified time is related

to the duration of the

function and does not

include the time required for

cleaning of the cavity by the

user.

When the steam cleaning function is

active, the lamp is off.

1. Fill the water drawer to the maximum

level (around 950 ml of water) until

the acoustic signal sounds or the

display shows the message.

2. Activate Steam Cleaning function -

S2. Refer to "Activating a cleaning

function".

The duration of the function is around

30 minutes.

An acoustic signal sounds when the

programme is completed.

3. Touch a sensor field to deactivate the

signal.

4. Wipe the internal surface of the

appliance with a non-abrasive

surface care sponge. You can use

warm water to clean the cavity.

After cleaning keep the appliance door

open for approximately 1 hour. Wait until

the appliance is dry. Let the appliance

dry fully with the door open. To speed up

the drying you can close the door and

heat up the appliance with True Fan

Cooking at temperature 150°C for

approximately 15 minutes. You can get

maximum effects of the cleaning function

if you manually clean the appliance

immediately after the function ends.

Repeat the procedure a second time if

the level of dirt is high.

12.8 Cleaning Reminder

This function reminds you that the

cleaning is necessary and that you

should perform the function: S2.

You can enable / disable this function in

the settings menu.

12.9 Steam generation system

- Descaling - S3

When the steam generator operates,

there is an accumulation and deposition

of limestone inside because of calcium

contents in the water. This can have a

negative effect on the steam quality, on

the performance of the steam generator

and on the food quality. To prevent this,

clean the steam generation circuit from

residual stone.

Select the function from the menu: .

The duration of the complete procedure

is about 2 hours.

The light in this function is off.

1. Remove all accessories.

2. Make sure that the water drawer is

empty. Activate Tank Emptying - S1

function if needed.

3. Put the tray on the first shelf position.

ENGLISH 41

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare