
35
If the appliance is not working
If the appliance doesn't work properly check the following
points before asking for service:
The flow of gas seems abnormal
Make sure that:
the flame speader holes are not obstructed;
the pressure regulator is working;
the bottle valve is completely open.
Gas smell in the room
Make sure that:
the gas valve is not open;
the gas supply tube is well positioned and in good
condition; remember to replace it at least once a year.
The oven doesn't heat
Make sure that the oven knobs are in the correct
worrking positions.
Cooking time is too long
Check that the temperature is correct for the type of
food to be cooked.
The cooker produces smoke
We advise you to clean the oven after use. Splashes
of fat can occur during the cooking of meat and, if the
oven isn't cleaned properly, these produce smoke and
bad smell. (see paragraph concerning cleaning).
The oven lamp doesn't work
The lamp has burnt out. To replace it follow the
instructions given in the relative paragraph.
If, after following all the above checks the appliance still
doesn't work, call your nearest Service Centre givin them
all the necessary information, such as model and serial
number of the appliance.
Never look for an escape of gas with
a match; use instead soap and water.
Maintenance - Technical assistance
Original Spare parts
This machine, before leaving the factory, has been tested
and studied by many experts and specialists, in order to give
you the best results.
Any repair work which needs to be carried out should be
done with the utmost care and attention.
For this reason we reccomend that for any problem you
contact the dealer who sold it to you, or our nearest
authorized Service Centre, specifying the nature of the
problem and the particular model which you own.
Original spareparts, certified by the manufacturer and
distributed under this trademark
can only bu purchased at our Authorized Technical
Assistance Centres.
The gas cocks must be periodically lubricated to ensure
good working and safety.
Maintenance should be performed as follows:
Remove the knob and panel after having taken out
fastening screws.
Loosen the two screws located at the sides of the cock
bar.
Remove the cone and clean it carefully.
Then, apply a thin layer of grease non soluble in water,
suitable for gas cocks. Take care not to obstruct the gas
flow holes by an excess of grease.
Reassemble the whole with utmost care performing the
operations described above inversely.
The Technical Assistance Service, through its numerous
authorized Centres, provides assistance to the most
important makes of electrical domestic appliances. In case
of necessity contact the nearest Centre by consulting the
telephone directory or, of course, the yellow pages under
the section Electrical Domestic Appliances/Repairs.
Guarantee
Your new appliance is under guarantee. You will find the
guarantee certificate attached. If it is missing, request it from
your retailer indicating the date of purchase, model and
identificaton number which are engraved on the appliances
small registration plate.
Retain the certificate in order to present it to the Technical
Assistance Service with the receipt or invoice in case of
necessity.
Should all these conditions not be satisfied, the Technical
Assistance Service will have to make a charge.
Kommentare zu diesen Handbüchern