Electrolux EHGC93CI Bedienungsanleitung Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 14
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
46mm
electrolux gas cooktops installation8
Installationprocedure Installationprocedure
Figure8
1. Thebenchcutoutshouldbemadeaspercutout
dimensionsinTable2andFigure5.
2. Adjacent walls, cupboards and protection for
combustible materials:Ensurethattheapplianceis
installedinaccordancewithclauses6.2.5and6.10.1.1
ofAS/NZS5601.1,orclauses6.9.1and6.9.5ofAS/
NZS5601.2withregardtoclearancestocombustible
surfacesandmaterials,andclearancestorangehoods
andexhaustfans.
Toensureclearancesof200mmfromburnerstovertical
combustiblesurfacesobservethedimensionsshownin
Figure8.
Clearancestocombustiblesurfacesmaybereducedif
combustiblesurfacesareprotectedinaccordancewith
clause6.10.1.2ofAS/NZS5601.1,orclause6.9.2of
AS/NZS5601.2.
3. Optional barrier:Abarriercanbeinstalledtoprevent
accidentalcontactwiththecooktopbase,wherethe
baseofthecooktopisaccessiblefrombelow(ieinside
acupboard,etc).Aminimumclearanceof15mmis
requiredbetweenthebaseandthebarrier.Thisbarrier
maybemadeofanynon-combustible,rigidmaterial.
4. AFOAMSEALhasbeenprovidedandistobeapplied
alongtheperimeterofthehob.
5. Fitthepositioningclipssuppliedtoensurethatthe
cooktopcannotmoveafterinstallation.
warning
Failure to fix the positioning clips could result in
loosening of the gas connection through movement
of the cooktop and a gas leak may result.
Installeightpositioningclipsintospecialholesonthesides
oftheappliance(seefigure7).Placeapplianceintocut-out
andcheckthefit.Theapplianceshouldbeagoodfitand
notmoveinanydirection.
96mm
Combustiblesurface
66mm
106mm
Flush fit installation method
Important note:Allcut-outsinthebenchtopareaareto
becarriedoutataspecialistworkshop.
Thecutmustbecleanandprecise,sincethecutedgeis
visibleonthebenchtopsurface.Thestabilityoffurniture
beingworkedonmustbeensuredfollowingthecut-outs.
Usespecialheatandwaterresistantbenchtops(e.g.
naturalstoneortiled).Seefigures5band6bforcutting
dimensions.
Placethehobintothecut-outandalignit,ensuringthe
gapsaroundtheedgesbetweenthehobandthebenchtop
areevenonallsides.Fitpositioningclipsasshowninfigure
6atthelocationpointsshowninfigure7.
Checkthefunctionandlocationofthehob.
Fillthegapsbetweenthehobandbenchtopwithasuitable
commercialsiliconesealantinacolourofyourchoice.
caution
Use of an unsuitable silicone sealant on natural stone
benchtops can cause permanent discolouration.
Beforethesiliconesealantstartstoformaskin,moisten
abladeoryourfingerwithasoapysolutionandsmooth
itover.Thehobshouldonlybeusedoncethesilicone
sealanthashardened.
Do not use foam seal in this application.
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare