Electrolux EKC6190 Bedienungsanleitung PDF herunterladen (Seite 12)

The ceramic hob

Automatic turning-off

For safety reasons, the power supply to the hob cuts out

after a certain time (1.5 to 6 hours). The higher the heat

of the hotplate, the earlier the power is cut:

Once the time for one hotplate has expired, all hot-

plates in use then cut out. A line appears in the control

window for these hotplates until you have reset the

controls.

Choosing suitable pans

Greater attention needs to be paid to the type and con-

dition of pans used on ceramic hobs than it does with

radiant hobs. Here are some points to remember:

• Check the pan bases. Bases which are convex (curve

outwards) will tend to spin on the hob and will not

conduct heat very well.

• Aluminium is a good conductor of heat, but it

can leave silver-coloured stains on the hob. You

can remove these stains with the hob cleaner

supplied with the cooker.

• Glass vessels and enamelled bases with a rough

pattern will – if pulled back and forth across the

surface – cause greater wear on the hob than

other materials.

To save you time and therefore energy, the contact

surface of the pan base should:

• be at least as large as the hotplate. If the base is

smaller than the hotplate, any spillages are quite

likely to burn onto the hob.

• be smooth or have a fine pattern

• be flat. It takes longer to heat a pan with a base

which curves in or outwards too much.

When you are buying new pans, it is advisable to

choose stainless steel ones with sandwich-type bases

(i.e. layers of different metals).

HEAT

POSITIONS

1– 23– 456– 9

Turning off

approx. hours

6541,5

aluminium

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Keine Kommentare

Electrolux EKC6190 Bedienungsanleitung Seite 12