
The cleaning reminder
goes out:
• after the end of the
pyrolytic cleaning.
• when you deactivate it in
the basic settings. Refer
to "Using the settings
menu".
12.5 Cleaning the oven door
The oven door has four glass panels.
You can remove the internal glass
panels to clean them.
CAUTION!
Do not use the appliance
without the glass panels.
The direction in which you
open the door depends on
your oven model. You open
the door from the right side
in some models and from
the left side in others.
1. Press the buttons at the sides of the
door trim (A) on the upper cover and
pull it upwards to remove it.
2. Hold the inner glass B tightly with
both hands and slide it upwards to
remove it from its initial position. Do
the same with the other glass panels.
Make sure that you tightly hold the
glasses to prevent them from falling.
3.
Clean the door with a wet sponge
and rub it dry with a soft cloth. Do not
use steel wool, acids or abrasive
cleaning agents because they can
damage the surface.
When the oven door is clean, install the
glass panels in the opposite sequence.
Make sure that you put the glass panels
(A, B and C) back in the correct
sequence. The glass panel (C) has a
small dot on the top, the middle panel (B)
has a decorative frame. In some models,
the glass panel (A) has screen printings.
In others, it is transparent. The screen-
printing zone must face the inner side of
the door. Make sure that after the
installation the surface of the glass panel
frame is not rough when you touch it.
12.6 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
www.electrolux.com28
Kommentare zu diesen Handbüchern