Electrolux ER6422T Bedienungsanleitung PDF herunterladen (Seite 4)

12

INSTALLATION

Positioning

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.

Best performance is obtained with ambient

temperature between +18°C and +43°C (class

T); +18°C and +38°C (class ST); +16°C and

+32°C (class N); +10°C and +32°C (class SN).

The class of your appliance is shown on its

rating plate.

Ensure that air can circulate freely around the

back, top and bottom of the cabinet.

If the appliance is positioned below an

overhanging kitchen unit, the minimum distance

between the top of the cabinet and the wall unit

must be at least 100 mm (Fig. 1-A).

The ideal solution, however, is the one shown in

Fig. 1-B (without an overhanging unit).

The appliance can be installed with its sides

touching adjacent kitchen units provided that air

can circulate freely around the back and top.

Accurate levelling is ensured by one or more

adjustable feet at the base of the refrigerator.

Important

The appliance must be earthed.

The power supply cable plug is provided with a

contact for this purpose.

If the domestic power supply socket is not

earthed, connect the appliance to a separate

earth in compliance with current regulations,

consulting a specialist technician.

The Manufacturer declines all responsibility

if the above safety precautions are not

observed.

This appliance complies with EEC directive

number 87/308 of 2/6/87 relative to radio

interference suppression.

This appliance complies with the

following E.E.C. Directives:

If this model, equipped with a magnetic

door lock, replaces an old appliance with a

catch, ensure that the latter cannot be

used before discarding it to prevent

children being trapped inside.

- 73/23 EEC of 19.2.73 (Low Voltage Directive)

and subsequent modiﬁcations;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modiﬁcations.

Cleaning the interior

Before using the appliance for the ﬁrst time,

wash the interior and all internal accessories

with lukewarm water and some neutral soap so

as to remove the typical smell of a brand-new

product, then dry thoroughly.

Do not use detergents or abrasive powders, as

these will damage the ﬁnish.

Fig. 1

NP008

A

B

100 mm 10 mm

10 mm

GB

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare