14 electrolux.com.au 15
TROUBLESHOOTING
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service
centre. Give the data from the rating plate and an error
message that comes on.
Make sure you operated the appliance correctly. If not the
servicing by a customer service technician or dealer will
not be free of charge, also during the warranty period. The
instructions about the customer service and conditions of
guarantee are in the guarantee booklet.
The sensor fields
become hot.
The cookware is too large or you put it
too near to the controls.
Put large cookware on the rear cooking zones
if necessary.
There is no signal
when you touch the
panel sensor fields.
The signals are deactivated. Activate the signals
(refer to “OffSound control”).
comes on
The automatic switch-off operates. Deactivate the appliance and activate it again.
comes on
The Child Safety Device or the Lock
function operates.
Refer to the chapter “Operating instructions”.
comes on
• No cookware on the cooking zone.
• Incorrect cookware.
• The diameter of the bottom of the
cookware is too small for the cooking
zone.
• The cookware do not cover the cross.
Put cookware on the cooking zone.
Use the correct cookware.
Use larger diameter cookware.
Cover the cross fully.
and number
comes on
There is an error in the appliance. Disconnect the appliance from the electrical
supply for some time. Disconnect the fuse
from the electrical system of the house.
Connect it again. If
comes on again, speak
to the after sales service.
comes on
There is an error in the appliance,
because either the cookware boils dry
or you’ve used incorrect cookware.
Overheating protection for cooking zone
operates. The automatic switch-off
operates.
Deactivate the appliance. Remove the hot
cookware. After approximately 30 seconds,
activate the cooking zone again. If the
cookware was the problem, the error message
goes out of the display, but the residual heat
indicator can stay. Let the cookware become
sufficiently cool and refer to “Cookware for
the induction cooking zone” to see if your
cookware is compatible with the appliance.
WARNING!
Refer to “Safety information” chapter.
IMPORTANT
BEFORE INSTALLATION
Before the installation of the appliance, record the
information below from the rating plate. The rating plate is
on the bottom of the appliance casing.
Model
PNC
Serial number
=
=
=
=
Built-in appliances
Only use the built-in appliances after you assemble the
appliance into correct built-in units and work surfaces that
align to the standards.
Connection cable
• Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single phase or two phase
connection.
min.
25mm
min.
5mm
min.
20mm
R 5mm
R 5mm
EHI845BB
EHI645BB
600mm
600mm
490
+1
mm
490
+1
mm
750
+1
mm
560+1mm
min.
500mm
min.
5mm
min.
50mm
IMPORTANT
If you use a protection box (an additional accessory
1
), the
front airflow space of 5mm and protective floor directly
below the appliance are not necessary.
You can not use the protection box if you install the
appliance above an oven.
INSTALLATION
(56 Seiten)
(64 Seiten)
(20 Seiten)
(68 Seiten)
(96 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern