
36
End of cooking digital programmer (Fig. 17)
In some models it has the function of switching off the
oven at the end of pre-selected cooking time.
The programmer has an electric clock which shows the
time of day and a timer with an acoustic signal.
Fig. 17 illustrates the programmer’s commands;
switches A and B carry out the necessary regulations
foreseen, as follows:
Switch A
Turned in a clockwise direction allows to adjust the time
shown on the digital clock (at the time of installation,
after electricity cuts, to advance or turn back, etc.).
Switch B
Turned in a clockwise direction sets:
- the length of cooking time (max. 210 minutes);
- interruption of the acoustic signal (position );
- manual operation (position ).
The above signals appear on face C.
Manual operation
The oven can be used normally, i.e. without any
programme. In such case, switch B of the programmer
should be turned in a clockwise direction until symbol
coincides with the mark on face C.
PROGRAMMING OF COOKING
Programmed operation of the oven
- Prearrange the food to be cooked;
-
turn switch B in a clockwise direction and preset the
minutes presumed for the end of cooking on switch C;
- turn the oven switch to the temperature required.
At the end of the pre-set time an acoustic signal will be
heard; to switch it off, turn knob B to symbol visible
on face C, corresponding to the mark on the face itself.
FO 0158
Fig. 17
Fig. 16
0
5
01
51
02
03
04
05
Mechanical minute-minder
The minute-counter may be set for a maximum time of
one hour. The regulation knob (fig. 16) must be turned
clock-wise until the 60-minute position is reached and
then anti-clockwise to the required time.
Once the pre-set time has elapsed, a signal will be
heard which automatically cuts out. The oven,
however, will remain on.
Kommentare zu diesen Handbüchern