
46
To adapt the appliance to a different kind of gas from
the one the appliance has been set for, follow the
instructions below in their order.
Replacement of rubber pipe holder (Fig. 30)
LPG preset range:
to set the range ready for natural gas, use rubber pipe
holder «A».
Natural gas preset range:
To set the range ready for LPG, use the rubber pipe
holder «B» (in the equipment). Always insert the gasket
«C» between the feeding pipe and the rubber pipe
holder. (Fig. 30)
ADAPTATION TO DIFFERENT
KINDS OF GAS
Replacement of nozzles and adjustment
Nozzle replacement:
- Remove the pan supports.
- Extract the caps and the wall baffles of the burners.
- Using a socket spanner 7 unscrew and remove (fig.
31) the nozzles replacing them with the ones required
for the kind of gas in use (see table 2).
Reassemble the parts following the same procedure
backwards.
These burners do not need any primary air regulation.
Replacement of the big-rapid and fish-kettle
burners nozzle (for models supplied with)
a) Remove the plate or glass lid by lifting it from the
relevant brackets;
b) remove the pan supports;
c) unthread the caps, baffles and burner covers;
d) dismount the two lid supports by unscrewing the
relevant fixing screws (fig. 32);
e) lift the working plate slightly from the bottom and
remove it, pushing it towards the front of the cooker;
f) FISH-KETTLE BURNER: with a no.7 spanner,
unscrew, remove and replace the nozzle (Fig. 33 -
A) with the proper one (see table 2 - "Nozzles").
g) BIG-RAPID BURNER: lift the burner mixing tube
(Fig. 34 - B), unscrew the nozzle (Fig. 34- A) by
means of a no. 7 spanner, remove and replace it
with the proper one (see table 2 - "Nozzles").
For primary air regulation, check the air regulator
(fig. 34 - D) is correctly positioned, that is each air
port (Fig. 34 - E) is 3 mm. wide, both for natural gas
use and LPG use. In case this condition is not
satisfied, undo the fixing screw (Fig. 34 - C) and
turn the air regulator until the measure is correct.
Remount the parts following the operations described
in reverse.
FO 0067-B
Fig. 30
FO 0392
Fig. 31
FO 0069
Fig. 32
FO 0070
Fig. 33
A
Fig. 34
A
B
E
C
D
FO 2102
Kommentare zu diesen Handbüchern