
14.3 Installing the oven under a
work surface
Before the installation, connect the oven
to the electrical supply. Refer to
"Electrical connection".
During installation in
combustible matter, NIN
SEV 1000 and fire protection
guidelines and regulations of
the Association of Cantonal
Fire Insurance shall be
strictly adhered to.
1. Place the appliance in front of the
recess and connect the mains plug.
Make sure the cable is free when you
slide the appliance.
2. Push the appliance into the recess.
A = appliance, N = recess
N 560-568 mm
115 mm
20
mm
442 mm
180
mm
A 595
mm
N 600
mm
A 592 mm
A 567
mm
N min.
550 mm
~50 mm
A A
B
3. Use a minimum of 2 screws to attach
the oven on the 2 sides (A).
When installing next to a wood-
fuelled boiler, a heat-proof and heat-
insulating plate must be mounted at
the height of the appliance and at
least 30 cm deep.
14.4 Electrical connection
WARNING!
If service is required always
disconnect the appliance
from the power supply.
Use a power cable of H05VV-F or higher.
Install the appliance with a socket supply
line. If there is no socket supply line, the
fixed home electrical system must
include an isolating device with at least a
3 mm-contact separation to enable a
simultaneous and all-pole cut off from the
mains (according to NIN SEV 1000). The
customer must have a socket for the
electrical connection that is accessible
and outside the coordination room. The
length of the connection cable must be
approximately 120 cm with lines
connected directly to the mains.
Only a qualified person can
connect the appliance to the
electricity supply.
1. Do the electrical connections as in
the connection illustration.
Phase definitions: L1, L2, L3 (or R, S,
T).
Voltage: 230V
L2
L3
400V
L1PE L2
400V
L1PE
1 2 3
45
1 2 3
45
400V 2N~
400V
400V
400V 3N~
N N
ENGLISH 47
Kommentare zu diesen Handbüchern